Schizophrenic
Harmless
Posts: 4
Registered: 27-6-2015
Member Is Offline
Mood: No Mood
|
|
Electricity: Blackout during experimenting, any idea's ?
I was busy with 2 experiments, one magnetic stirrer was on for purification and the distillation apparatus was build. I turned on the reflux pump then
I turned on the heating mantle.
At that point everything went dark in the lab and there was no electricity anymore. I checked all the mechanical fuses, they where all above in the
right position, in the other rooms there was indeed electricity.
This is strange as the mechanical fuse of the lab didn't move, it was in exactly the same position as before: which means that there should be
electricity on that place. But there is no electricity which is a very strange situation !
What might cause this blackout, I'm now 12 hours later and still have no electricity in the lab. This might be very dangerous if I don't know all the
possible reasons.
What should you ?
|
|
|
m1tanker78
National Hazard
Posts: 685
Registered: 5-1-2011
Member Is Offline
Mood: No Mood
|
|
If by 'fuse' you mean circuit breaker then swith it off and back on. Some breakers dont give a visual cue when they trip.
Also, if your lab outlet is GFCI, press the reset button. Sometimes the gfci outlet is in a different location within the same room/circuit.
Chemical CURIOSITY KILLED THE CATalyst.
|
|
|
Loptr
International Hazard
Posts: 1348
Registered: 20-5-2014
Location: USA
Member Is Offline
Mood: Grateful
|
|
Yes, either switching on/off the breakers to reset or look for a ground fault outlet. It might be in the bathroom. Sometimes they use one GFCI for an
entire house.
|
|
|
Pyro
International Hazard
Posts: 1305
Registered: 6-4-2012
Location: Gent, Belgium
Member Is Offline
Mood: No Mood
|
|
I get a problem with GFI's that the won't re-engage until I flip down all the breakers and then turn them back on... it's like a ghost in the system
:O
The GFI on land used to blow every half hour until I bridged it (Every technician freaks out at this  ) I think it has got to do with our EM field but am not sure... can anyone verify this?
all above information is intellectual property of Pyro.  |
|
|
subsecret
Hazard to Others
Posts: 424
Registered: 8-6-2013
Location: NW SC, USA
Member Is Offline
Mood: Human Sadness - Julian Casablancas & the Voidz
|
|
Find the circuit breaker and turn it on and off. If you still have no power, check the continuity of various parts of the circuit: switches, outlets,
etc just to see if there's anything wrong with those specific parts. Wiring almost never fails
This is one of my worst fears in the lab. Distilling bromine, lose power, everyone dies. Always have a scrubber or a cold trap ready in case of a
power outage, so you can run a hose into it to condense/neutralize vapors.
My GFCI sometimes trips for no reason, but I suspect it's the power strip. I've actually changed the strip since, and I haven't had any more problems.
Fear is what you get when caution wasn't enough.
|
|
|
ave369
Eastern European Lady of Mad Science
Posts: 596
Registered: 8-7-2015
Location: No Location
Member Is Offline
Mood: No Mood
|
|
I prefer not to use electricity in my experiments, because blackouts are very common where I live. There are processes where you can't do without it,
such as electrolysis, or concentrating battery acid by evaporation of water (the latter can be done on a propane home stove, but it's a risk of
ruining it). But mostly I prefer to use alcohol or propane based heating and wind instead of a fume hood.
[Edited on 12-7-2015 by ave369]
|
|
|
zed
International Hazard
Posts: 2283
Registered: 6-9-2008
Location: Great State of Jefferson, City of Portland
Member Is Offline
Mood: Semi-repentant Sith Lord
|
|
You will get this straightened out. After you do, install a larger circuit breaker. Run a larger caliber of Romex also, if required.
Your power needs are great, your current electrical capacity....appears to be small.
Also be aware that in some instances, battery back-up may be helpful. The same type of battery systems that can be used to back-up your computer, in
the event of power failure....could be used to supply emergency electricity to some critical lab stuff. Thus, giving you a few minutes juice for
safe shutdown.
Computer back-up systems, used to be as common as fleas.
Inverter plus Car battery is also an option. http://www.harborfreight.com/catalogsearch/result?q=inverter
[Edited on 14-7-2015 by zed]
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
