chemrox
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2961
Registered: 18-1-2007
Location: UTM
Member Is Offline
Mood: LaGrangian
|
|
oil diffusion pumps
I need to find some write-ups on installing oil diffusion pumps. They all seem to have these big flanges on them; why? what to do with them?
"When you let the dumbasses vote you end up with populism followed by autocracy and getting back is a bitch." Plato (sort of)
|
|
bobm4360
Hazard to Self
![*](images/xpblue/star.gif)
Posts: 59
Registered: 18-4-2011
Location: On a wretched little island.
Member Is Online
Mood: No Mood
|
|
They are very high flow, but need a backing pump like a rotary pump to get them down to the very low pressures where they work. They are primarily
used in physics apps like vacuum tubes, optical coating, cyclotrons and other accelerators, etc. The large flanges are because they hook up to a very
low-resistance system, commonly directly to the vacuum chamber. www.belljar.net has a lot of good info, and John Strong's "Procedures in Experimental Physics" (1938), although dated gives applications and small
vacuum system designs.
Regards,
Bob
PS Also check out fusor.net
Bob
[Edited on 2/12/2014 by bobm4360]
|
|
Texium
|
Thread Moved 21-11-2023 at 13:51 |