Sciencemadness Discussion Board
Not logged in [Login ]
Go To Bottom

Printable Version  
Author: Subject: Preparation of propionaldehyde
phendrol
Harmless
*




Posts: 34
Registered: 13-6-2012
Member Is Offline

Mood: sock puppet

[*] posted on 6-9-2013 at 00:48
Preparation of propionaldehyde


Hey!

None of the places I supply offer propionaldehyde. Does anybody have a reference to a doable preparation method. All I could find were catalytic, vapor phase, industrial processes using allyl alcohol as the starting material. High temperatures and pressure are required and I'm looking for something I could do using just my glassware.
View user's profile View All Posts By User
woelen
Super Administrator
*********




Posts: 8014
Registered: 20-8-2005
Location: Netherlands
Member Is Offline

Mood: interested

[*] posted on 6-9-2013 at 01:05


Oxidation of 1-propanol with acidified dichromate in aqueous solution seems easiest to me. Just assure that you never have excess dichromate in the solution, because that will lead to further oxidation to propionic acid. I would prepare a solution of 1-propanol in dilute H2SO4 (e.g. 10%) and then drop in (while stirring) the solution of K2Cr2O7 or Na2Cr2O7. Try to use so much dichromate that there is just enough for the oxidation of all of the 1-propanol. Assure that there is an excess amount of acid.

Isolation of the propionaldehyde should not be that difficult. Its boiling point is much lower than that of water, 1-propanol and propionic acid. If it forms azeotropes, then things may be more difficult, I'm not sure about that. I would first try on a small scale.




The art of wondering makes life worth living...
Want to wonder? Look at https://woelen.homescience.net
View user's profile Visit user's homepage View All Posts By User
DJF90
International Hazard
*****




Posts: 2266
Registered: 15-12-2007
Location: At the bench
Member Is Offline

Mood: No Mood

[*] posted on 6-9-2013 at 01:30


Ideally you would add 1-propanol to a hot solution of acidified dichromate, such that the aldehyde distills as it is formed.

It depends on the scale you want to work on, your capabilities, and your resources. For small scale, chromium VI isn't too bad, and selective conditions for the aldehyde can be used (e.g. PCC in DCM). On a larger scale, the chromium wastes become troublesome/excessive and it's better to use another method. Given the relatively low cost of the starting alcohol, it probably doesn't warrant the use of expensive reagents like oxalyl chloride (Swern) or TPAP (even in catalytic amounts). If you're after a fair quantity of the propionaldehyde, perhaps an approach using catalytic TEMPO/KBr/NaOCl/DCM would be fairly cheap and selective.
View user's profile View All Posts By User
bobm4360
Hazard to Self
**




Posts: 60
Registered: 18-4-2011
Location: On a wretched little island.
Member Is Offline

Mood: No Mood

[*] posted on 6-9-2013 at 10:19


OrgSyn has this:
http://www.orgsyn.org/orgsyn/pdfs/CV2P0541.pdf

Regards,
Bob
View user's profile View All Posts By User
thanos thanatos
Harmless
*




Posts: 23
Registered: 8-9-2011
Member Is Offline

Mood: No Mood

[*] posted on 6-9-2013 at 14:37


If you can get the electrolysis method referenced in that OrgSyn paper - namely Reitlinger, Z. Elektrochem. 20, 261 (1914); Feyer, ibid. 25, 142 (1919) - to work, it would be ideal for the amateur experimenter. No need for carcinogenic oxidizers, just calcium chloride or dilute sulfuric acid and propyl alcohol, plus the electrolytic cell, which can be used for lots of things. Anybody try this method?
View user's profile View All Posts By User
Magpie
lab constructor
*****




Posts: 5939
Registered: 1-11-2003
Location: USA
Member Is Offline

Mood: Chemistry: the subtle science.

[*] posted on 6-9-2013 at 15:16


Unitized Experiments in Organic Chemistry, 4th ed by Brewster et al has a preparation for propionaldehyde. It specifies a sodium dichromate/H2SO4 solution added slowly to to the hot alcohol. A 3-neck RBF is used as pot connected to a condenser via a Claisen adapter so that the aldehyde is immediately removed to prevent further oxidation. This is likely a version of the Org Syn procedure, simplified for student use.

Brewster's 1st edition has a similar procedure for making butyraldehyde from 1-butanol. I have tried this procedure quite a few times with only limited success.

Making propionaldehyde with propylene glycol looks intriguing as I could use my tube furnace for that. The glycol should be OTC as RV anti-freeze.

[Edited on 6-9-2013 by Magpie]




The single most important condition for a successful synthesis is good mixing - Nicodem
View user's profile View All Posts By User
phendrol
Harmless
*




Posts: 34
Registered: 13-6-2012
Member Is Offline

Mood: sock puppet

[*] posted on 11-9-2013 at 13:58


Heating calcium formate and calcium propionate also seems easy and straightforward. Does anyone have some more info on this? I know that more aldehydes and ketones can be produced using dry distillations. Anyone has some info or experience with this matter?
View user's profile View All Posts By User
Maximus
Harmless
*




Posts: 8
Registered: 10-1-2013
Location: Roman Empire
Member Is Offline

Mood: Lying on a triclinium

[*] posted on 13-9-2013 at 08:32


What about dry distillation of Propylene glycol with KHSO4/NaHSO4, like the dry distillation of glycerol with KHSO4 to obtain acrolein (After a Pinacol Rearrangement and dehidration)
View user's profile View All Posts By User
Nicodem
Super Moderator
*******




Posts: 4230
Registered: 28-12-2004
Member Is Offline

Mood: No Mood

[*] posted on 13-9-2013 at 08:55


Quote: Originally posted by phendrol  
Heating calcium formate and calcium propionate also seems easy and straightforward. Does anyone have some more info on this? I know that more aldehydes and ketones can be produced using dry distillations. Anyone has some info or experience with this matter?

There is a reference for that in the Organic Syntheses article: Linneman, Ann. 161 (1872) 18-25, DOI: 10.1002/jlac.18721610104
Quote: Originally posted by Maximus  
What about dry distillation of Propylene glycol with KHSO4/NaHSO4, like the dry distillation of glycerol with KHSO4 to obtain acrolein (After a Pinacol Rearrangement and dehidration)

It is not called dry distillation, if you are distilling a liquid from a liquid. Anyhow, you need an acid catalyzed vapor phase rearrangement for such glycols in order to obtain the corresponding aldehydes. Enolizable aldehydes are not stable enough toward acids in the liquid phase. The rearrangement of propylene oxide over silica gel in the vapor phase at 300 °C is described in the patent cited in the Org. Synth. article. Often, the same conditions work for glycols as well, as the reaction mechanism is similar. Particularly since another example in that review is the rearrangement of propylene glycol to propionaldehyde at 500 °C, apparently uncatalyzed (DOI: 10.1002/jlac.19043350108).




…there is a human touch of the cultist “believer” in every theorist that he must struggle against as being unworthy of the scientist. Some of the greatest men of science have publicly repudiated a theory which earlier they hotly defended. In this lies their scientific temper, not in the scientific defense of the theory. - Weston La Barre (Ghost Dance, 1972)

Read the The ScienceMadness Guidelines!
View user's profile View All Posts By User
Maximus
Harmless
*




Posts: 8
Registered: 10-1-2013
Location: Roman Empire
Member Is Offline

Mood: Lying on a triclinium

[*] posted on 14-9-2013 at 00:53


Thank you for your wisdom, Nicodem!
View user's profile View All Posts By User

  Go To Top