Sciencemadness Discussion Board
Not logged in [Login ]
Go To Bottom

Printable Version  
Author: Subject: How to tell when HNO3 distillation is done
Thanatops1s
Hazard to Self
**




Posts: 54
Registered: 24-6-2013
Member Is Offline

Mood: No Mood

[*] posted on 3-9-2013 at 09:55
How to tell when HNO3 distillation is done


How to tell when it's time to call it quits, for example when production slows to a drop every X number of seconds? I just want to make sure I'm getting the most out of my reagents.
View user's profile View All Posts By User
bfesser
Resident Wikipedian
Thread Moved
3-9-2013 at 10:09
Pyro
International Hazard
*****




Posts: 1305
Registered: 6-4-2012
Location: Gent, Belgium
Member Is Offline

Mood: No Mood

[*] posted on 4-9-2013 at 08:22


just keep heating until the temperature read on the thermometer goes over the BP of HNO3, also the production of NO2 will cease.



all above information is intellectual property of Pyro. :D
View user's profile View All Posts By User
Pulverulescent
National Hazard
****




Posts: 793
Registered: 31-1-2008
Member Is Offline

Mood: Torn between two monikers ─ "hissingnoise" and the present incarnation!

[*] posted on 14-9-2013 at 04:49


Quote:
. . . just keep heating until the temperature read on the thermometer goes over the BP of HNO3, also the production of NO2 will cease.

HNO3 boils @~83°C but distills from H2SO4 @ between 90 and 121°C!
When finished, the temp. will start to rise fairly quickly and heating may then be stopped . . .





"I know not with what weapons World War III will be fought, but World War IV will be fought with sticks and stones"

A Einstein
View user's profile View All Posts By User
eidolonicaurum
Hazard to Self
**




Posts: 71
Registered: 2-1-2014
Location: Area 51
Member Is Offline

Mood: Hydric

[*] posted on 9-1-2014 at 08:24


I wait until a drop every 5 seconds or so. Chances are, when the distillate is not coming over very quickly anymore, anything left in the flask is removing, unless its very precious. Ie. I just get bored, and stop when its about done as above.



View user's profile Visit user's homepage View All Posts By User
Metacelsus
International Hazard
*****




Posts: 2539
Registered: 26-12-2012
Location: Boston, MA
Member Is Offline

Mood: Double, double, toil and trouble

[*] posted on 9-1-2014 at 18:33


On distillations such as this, I wait until the temperature in the still head peaks and then starts to decrease. This usually signifies the end of vapor production. Patience is key. However, this only works with fractions far in boiling point (e.g. nitric and sulfuric acids).



As below, so above.

My blog: https://denovo.substack.com
View user's profile View All Posts By User

  Go To Top