veganalchemist
Harmless
Posts: 30
Registered: 3-8-2010
Location: UK
Member Is Offline
Mood: No Mood
|
|
Melting point apparatus
Hello all,
this is my first post but have been around for a while.
I want to build a melting point apparatus.
I plan to use a heating cartridge (about 200 W) but need to control the power input.
A Variac would but really need to control the heating rate.
Would a PID controller work?
|
|
ScienceSquirrel
International Hazard
Posts: 1863
Registered: 18-6-2008
Location: Brittany
Member Is Offline
Mood: Dogs are pets but cats are little furry humans with four feet and self determination!
|
|
You can do it with a big test tube filled with mineral oil.
To stir you want to use a coil of wire or if you want to get sophisticated a flea and a magnetic stirrer.
A thermometer of an appropriate range with a sealed capillary filled with the test substance is strapped to it and placed in the oil.
Heat very slowly with stirring using a small colourless gas flame.
If you want to be really traditional, puff at a long stemmed pipe and stroke your beard while doing the mp!
|
|
mr.crow
National Hazard
Posts: 884
Registered: 9-9-2009
Location: Canada
Member Is Offline
Mood: 0xFF
|
|
Well a PID controller would be great for setting a desired temperature. For a melting point you want a slow constant temperature increase, not a
feedback loop.
To control the power to a heating element use a standard dimmer switch in an electrical box. This also works great for heating mantles.
Double, double toil and trouble; Fire burn, and caldron bubble
|
|
chemrox
International Hazard
Posts: 2961
Registered: 18-1-2007
Location: UTM
Member Is Offline
Mood: LaGrangian
|
|
Squirrel describes an alternate to the Thiele tube. Thiele tubes can be had from ebay and most science supply stores. Their use is a time honored
way to get melting and boiling points. The Thiele tube obviates the need for a stirring "flea" by providing constant flow of the hot oil due to
convestion through the tube. However, to avoid the messiness of mineral oil and improve precision a melting point apparatus is preferred. However,
you can't do boiling points with (most) melting point machines. Besides this is clearly a DIY adventure, like building a radio.
"When you let the dumbasses vote you end up with populism followed by autocracy and getting back is a bitch." Plato (sort of)
|
|
veganalchemist
Harmless
Posts: 30
Registered: 3-8-2010
Location: UK
Member Is Offline
Mood: No Mood
|
|
I work at a local Uni and the undergrads use tubes filled with oil for melting points.
I want to build something a bit more sophisticated, where I can control the temp rate.
|
|
watson.fawkes
International Hazard
Posts: 2793
Registered: 16-8-2008
Member Is Offline
Mood: No Mood
|
|
Quote: Originally posted by mr.crow | Well a PID controller would be great for setting a desired temperature. For a melting point you want a slow constant temperature increase, not a
feedback loop. | PID controllers can be used for a ramp, though the math is a bit more involved. The error
term is calculated from the target temperature as a function of time, not simply as a constant. That said, it's desirable that the thermal mass of the
sample holder be rather larger than the sample, to make it easier to get a consistent ramp, and also that thermal conductivity be high, so that
temperature consistency is good.
|
|