Chemgineer
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 207
Registered: 25-5-2021
Member Is Offline
|
|
Potassium Chlorate - Yellow Colour Change
I've been electrolysing a solution of Muriate of Potash (fertiliser grade Potassium Chloride) after first filtering out all of the brown particulate.
It works really well.
What i'm interested in is when I reuse the solution I can get a bright yellow colour after adding more KCL to bring it back to saturation. This fairly
quickly goes colourless again once the electrolysis starts.
What could the colour be? I am wondering if this is Sodium Chlorate in solution from sodium impurities in my Muriate?
[Edited on 5-6-2021 by Chemgineer]
|
|
hissingnoise
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3940
Registered: 26-12-2002
Member Is Offline
Mood: Pulverulescent!
|
|
Chlorine in solution, most likely ─ from acid hydrolysis of some hypochlorite...
|
|
Chemgineer
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 207
Registered: 25-5-2021
Member Is Offline
|
|
Thanks, that makes sense and then it releases as Chlorine gas once the electrodes get to work.
|
|
mysteriusbhoice
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 477
Registered: 27-1-2016
Member Is Offline
Mood: Became chemistry catboy Vtuber Nyaa
|
|
yellow color is due to potassium hypochlorite and usually with pH of 11 these cells operate at a high enough pH that considerable hypochlorite remains
dissolved as the cell runs.
I hope you didnt add more KCl as your anodes were left unpowered in the cell or rather you never left your anodes unpowered in a cell if its MMO as
that can lead to highly toxic RuO4 which is a deep yellow color being produced.
|
|
Chemgineer
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 207
Registered: 25-5-2021
Member Is Offline
|
|
Thanks for the explanation, I never leave electrodes in the cell unpowered so nor worries there. The yellow change happened literally while adding
the KCL, it looks like i'm pouring a yellow liquid in so whatever it is reacts between KCL and my chlorate brine.
It clears up again once the cell is run for a few minutes.
Also last time I checked after adding KCL, PH test paper appeared to show the cell was around PH 5 or 6. (My test strip just stayed yellow.)
|
|