nguyenvannam2904
Harmless
Posts: 6
Registered: 10-2-2019
Member Is Offline
|
|
Question with Venturi system for vacuum filtration and lowering boiling point
When finding a suitable vacuum pump system for my lab, I found out Nurdrage video on Youtube about Venturi aspirator pump.
The link : https://www.youtube.com/watch?v=tYLlkTDstmo.
In video, he said that we can attach the aspirator vacuum pump with a gas compressor instead of water pump to avoid messing.
However, I don't know the specifications requirement for the gas compressor ( pressure in PSI or flow rate in litre/min )
Have you guy have any experience in this field? Hope to have the solution for my question <3
[Edited on 5-8-2020 by nguyenvannam2904]
|
|
Syn the Sizer
National Hazard
Posts: 600
Registered: 12-11-2019
Location: Canada
Member Is Offline
|
|
I believe the water pressure in an average home is limited to ~50psi by a regulator, so I would start with that and go from there.
Do a test vacuum distilling water with that and see how low you can boil water, if it is not enough raise the pressure on the compressors regulator. I
believe most household compressors are between 120psi and 200psi, but I could be wrong in that range.
But to be honest, my opinion is get a bucket and a suitable water pump, messing should be an issue as long as the outlet hose goes back into the
bucket. I am sure a water pump is more energy efficient that the compressor.
If you are going the compressor route, I would just find a way to use the compressor inlet as a vacuum, use a couple traps to catch damaging vapours
to protect the motor and save the hassle of figuring out the aspirator pump with the compressor.
Edit:
Flow rate should be limited by the inlet/outlet on the aspirator.
[Edited on 5-8-2020 by Syn the Sizer]
|
|
Syn the Sizer
National Hazard
Posts: 600
Registered: 12-11-2019
Location: Canada
Member Is Offline
|
|
The mods will fix it, place this in reagents and apparatus acquisition, and remove your other post.
|
|