nimgoldman
Hazard to Others
Posts: 303
Registered: 11-6-2018
Member Is Offline
|
|
Refreshing old Sodium Dithionite
I have about 1.5 year old sample of commercial sodium dithionite powder.
I stored it in plastic bottle and it seems to deteriorated over time. It smells sharply of SO2 and the aqueous solution turns yellow. I use it for
silver precipitation and it still works.
I am thinking of recrystallizing it but it is also known to be unstable in water, especially acidic.
How would you go about cleaning the old dithionite? My first thought is to dissolve it in dilute ammonia soln. and add enough ammonia to make the
solution basic/neutral, then concentrate it to the point of saturation, let the crystals of sodium dithionite precipitate and finally dry in a vacuum
desiccator.
I am going to store it in a glass Wheaton bottle which seems to be more airtight than plastic...
|
|
woelen
Super Administrator
Posts: 8001
Registered: 20-8-2005
Location: Netherlands
Member Is Offline
Mood: interested
|
|
Most likely your sodium dithinite has not deteriorated. The material is quite stable when dry, but a solution in water decomposes. The coloring of the
solution is normal, it decomposes at low pH, but also in neutral solution. The smell of SO2 also is normal for dithionites. So, just repackage it in a
glass bottle with a good airtight cap.
|
|
DavidJR
National Hazard
Posts: 908
Registered: 1-1-2018
Location: Scotland
Member Is Offline
Mood: Tired
|
|
I agree - I don't think it's worth attempting to purify it.
|
|
nimgoldman
Hazard to Others
Posts: 303
Registered: 11-6-2018
Member Is Offline
|
|
Alright, I will just repack it.
I found the 20% sodium dithionite soln. is only slightly acidic and adding a few drops of dilute ammonia easily make the soln. strongly basic, in
which case only very slight yellowing occured upon standing.
|
|
woelen
Super Administrator
Posts: 8001
Registered: 20-8-2005
Location: Netherlands
Member Is Offline
Mood: interested
|
|
Yes, at high pH a solution of dithionite is more stable. In the long run, however, any aqueous solution will decompose.
If you experiment with the salt, be careful with its reactivity. Under certain conditions, when it becomes somewhat damp, it can react with oxygen
from air and so much heat can be produced in that reaction that a fire is started. So, repackaging should be done quickly and carefully, outside in a
place where an accidental fire does not cause a disaster.
|
|