6dthjd1
Hazard to Self
Posts: 71
Registered: 30-6-2018
Member Is Offline
|
|
methyl chloride from dimethyl sulfate
Is it possible to synthesize methyl chloride from reacting sodium chloride with dimethyl sulfate?
|
|
|
Metacelsus
International Hazard
Posts: 2539
Registered: 26-12-2012
Location: Boston, MA
Member Is Offline
Mood: Double, double, toil and trouble
|
|
I've never done it but it should be possible. Methyl chloride can be separated from the mixture (it's a gas) to drive the equilibrium forward.
Is there a reason you want to do this?
|
|
|
6dthjd1
Hazard to Self
Posts: 71
Registered: 30-6-2018
Member Is Offline
|
|
Yes, to make methylphosphonus dichloride from dissolving methyl chloride in tetrachloroethane mixed with aluminum trichloride and phosphorus
trichloride
|
|
|
Metacelsus
International Hazard
Posts: 2539
Registered: 26-12-2012
Location: Boston, MA
Member Is Offline
Mood: Double, double, toil and trouble
|
|
Sounds like someone wants to make nerve gas . . .
But seriously, it's best if you stay away from that. Even if you're not trying to make chemical weapons, having the precursors can get you in quite a
bit of trouble. (And methyl phosphonous dichloride is itself quite nasty.)
|
|
|
6dthjd1
Hazard to Self
Posts: 71
Registered: 30-6-2018
Member Is Offline
|
|
Laws vary. Ohio and Indiana can be quite tough, for instance, just see the definition of manufacture in 2925.04 ORC. It practically could be used to
ban HCl gas synthesis.
Methylphosphonus dichloride is quite possibly an amenable route to nerve gases. However, some may contend it's an arduous process and other techniques
are easier, if not nearly imperceptibly safer than the dichloromethylphosphine route, if one wanted nerve gases. Considering its potentially
pyrophoric.
It's quite rare, sigma-Aldrich sells 10 ml for about $450.
Phosphorus trichloride itself is quite vicious to work with in my experience. Do you believe dichloromethylphosphine behaves similarly. It's more
toxic than the trichloride but I believe it just as volatile as the trichloride. I do believe it's odor is more pronounced, however.
|
|
|
6dthjd1
Hazard to Self
Posts: 71
Registered: 30-6-2018
Member Is Offline
|
|
Some observations on the purported reaction of Dimethyl sulfate with sodium chloride:
A few grains of sodium chloride as sea salt was added to a few milliliters of dimethyl sulfate in a 250 ml round bottom boiling flask. The mixture
was swirled to ensure even saturation of NaCl. The flask was subject to a mostly yellow flame of a Bunsen burner until effervescence was observed.
The height of the flame was lowered to ensure less evaporation of dimethyl sulfate. A match was placed near the top of the flask to observe if
ignition occurred. No ignition was observed.
Several days later
A visible excess of dimethyl sulfate of approximately 10 ml was placed in a 250 ml round bottom flask. A few grams of sodium chloride was added to the
dimethyl sulfate. Some swirling commenced to ensure even saturation of the NaCl. A balloon was placed on the head of the flask to observe any gas
collection. The balloon was deflated. The next day in the evening the balloon was inflated somewhat but not severely.
Conclusion:
At this point the reaction of Dimethyl sulfate with sodium chloride may not be an amenable reaction for the synthesis of methyl chloride. Its presence
in this reaction is doubtful because were it present it would have inflamed. I will consider igniting the balloon but am aware the dimethyl sulfate
vapors are also inflammable albeit less flammable than the methyl chloride vapors.
|
|
|
SWIM
National Hazard
Posts: 970
Registered: 3-9-2017
Member Is Offline
|
|
Seems like it ought to me possible to make it from methyl alcohol with HCl, ZnCl, or some other combo like that.
Sure works for ethyl chloride.
Not that I don't appreciate a flask of boiling dimethylsulfate as well as the next person.
|
|
|
6dthjd1
Hazard to Self
Posts: 71
Registered: 30-6-2018
Member Is Offline
|
|
I should note that this best be done at a minimum outdoors which is where I performed it. Doing this inside may not be imminently harmful but it is
likely as safe as Russian roulette. During the early to mid 19th century, it seems that the chemists working with dimethyl sulfate lived... luckily.
|
|
|
wakatutu
Harmless
Posts: 31
Registered: 23-2-2017
Member Is Offline
Mood: Mostly Harmless
|
|
Methyl Chloride unto itself is a nasty beast. It has all the same symptoms as methyl bromide and methyl iodide poisoning.
I made it by the accidental reduction of dichloromethane with HCl and copper salts. You might be able to do zinc, iron, copper, aluminum, etc. I
don't know of any papers detailing the reduction but it should be completely possible. Chloromethane is unsurprisingly quite soluble in DCM so it
might stick around rather than volatizing, making itself available for further reduction to methane, but I don't know.
|
|
|
6dthjd1
Hazard to Self
Posts: 71
Registered: 30-6-2018
Member Is Offline
|
|
How did your accidental reduction go?
|
|
|
wakatutu
Harmless
Posts: 31
Registered: 23-2-2017
Member Is Offline
Mood: Mostly Harmless
|
|
http://www.sciencemadness.org/talk/viewthread.php?tid=77162#...
a detailed report on the accidental reduction, and subsequent formation of a solid idea of what had happened.
http://www.sciencemadness.org/talk/viewthread.php?tid=110096...
my attempt to spark discussion on why the reduction took place
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
