cnidocyte
Hazard to Others
Posts: 214
Registered: 7-7-2010
Member Is Offline
Mood: No Mood
|
|
Dissolving MnO2
What solvent can dissolve manganese dioxide? Petroleum distillates don't seem to dissolve this stuff at all.
[Edited on 3-9-2010 by cnidocyte]
|
|
|
ScienceSquirrel
International Hazard
Posts: 1863
Registered: 18-6-2008
Location: Brittany
Member Is Offline
Mood: Dogs are pets but cats are little furry humans with four feet and self determination! 
|
|
Manganese dioxide is not really soluble in anything at all.
It will react with hydrochloric acid to form manganese chloride, chlorine and water.
But you have gone from Mn IV to Mn II.
The hydrated salt is a light and quite pretty pink by the way!
|
|
|
cnidocyte
Hazard to Others
Posts: 214
Registered: 7-7-2010
Member Is Offline
Mood: No Mood
|
|
Ah right. So its going to be tricky cleaning up the mess I've made with this stuff lol.
|
|
|
chemrox
International Hazard
Posts: 2961
Registered: 18-1-2007
Location: UTM
Member Is Offline
Mood: LaGrangian
|
|
I've added it to refluxing chloroform...
"When you let the dumbasses vote you end up with populism followed by autocracy and getting back is a bitch." Plato (sort of)
|
|
|
woelen
Super Administrator
Posts: 8012
Registered: 20-8-2005
Location: Netherlands
Member Is Offline
Mood: interested
|
|
You can cleanup a mess made of MnO2 with a mix of hydrochloric acid and sodium sulfite. It does react with this mix, leaving behind almost colorless
Mn(2+) which can be rinsed away with water.
|
|
|
Methansaeuretier
Harmless
Posts: 45
Registered: 24-5-2010
Location: Europe
Member Is Offline
Mood: strongly alkaline
|
|
It does dissolve very well and fast in a solution of sodium sulfite and any stronger acid (H2SO4, etc.). It will create dihydrogen sulfite in situ
which is able to reduce MnO2 and create soluble MnSO4
But I think it may also dissolve in many other acids.
Btw. it does dissolve also in HCl/HBr but be careful using them... chlorine/bromine is generated because MnO2 is able to oxidise these acids to H2O
and chlorine/bromine.
[Edited on 5-9-2010 by Methansaeuretier]
|
|
|
12AX7
Post Harlot
Posts: 4803
Registered: 8-3-2005
Location: oscillating
Member Is Offline
Mood: informative
|
|
Also, any mineral acid with H2O2, which acts as a reducing agent in this case, producing excess O2 gas. This works nicely for producing colorless
MnSO4 and near-colorless MnCl2.
Solutions of Mn(II) tend to darken with exposure to air (forming Mn(III) species), a dash of H2O2 cleans this up.
If you are hard set on dissolving MnO2 per se, you might be able to find a salt which can. Examples are mixtures of sodium, potassium, magnesium,
etc. nitrates, sulfates or chlorides. Finding a combination which does not react may be difficult (MnO2 is oxidized to MnO4(2-) by oxidizers like
nitrate and chlorate, and it's reduced by chlorides, producing Cl2 gas and Mn2O3).
Tim
|
|
|
franklyn
International Hazard
Posts: 3026
Registered: 30-5-2006
Location: Da Big Apple
Member Is Offline
Mood: No Mood
|
|
For cleanup the methods already cited are adequate , for
true solvation without chemical reaction options are limited.
Metal oxides as in this case MnO2 are soluble to some extent
in a mixture of 1 part Choline Chloride to 2 parts of Urea. See
http://www.sciencemadness.org/talk/viewthread.php?tid=10529
Propylene Carbonate may also serve the purpose
http://www.sciencemadness.org/talk/viewthread.php?tid=8645#p...
.
|
|
|
etack
Unregistered
Posts: N/A
Registered: N/A
Member Is Offline
|
|
Hello,
I have 100# of Tantalum anodes coated with MnO2 and a layer of Ag on top. The material is 80% Ta and the remainder MnO2 and Ag
I want to remove the MnO2 and the silver in the easiest way possible.
I know that HCl will dissolve MnO2 and that HNO3 will dissolve the Ag. but some of the anodes are quite small so I am trying to reduce the chance of
making AgCl.
My question is MnO2 will dissolve in a mineral acid and with H2O2. Do you think that HNO3 and H2O2 will accomplish this? If so what % H2O2 would I
need to use.
My objective is to remove the MnO2 and reclaim the silver with Cu.
Eric
|
|
|
AJKOER
Radically Dubious
Posts: 3026
Registered: 7-5-2011
Member Is Offline
Mood: No Mood
|
|
Here is some background on the electrochemistry of some processes employing MnO2.
One source, "Electrochemical phenomena in MnO2–FeS2 leaching in dilute HCl. part 2 : studies on polarization measurements", by R.K. Paramguru1 at
the Regional Research Laboratory (Council of Scientific and Industrial Research) Bhubaneswar, India, link: http://www.sciencedirect.com/science/article/pii/S0008443398... citing an electrochemical phenomena involving MnO2–FeS2 dissolution in dilute
HCl.
I find this interesting given this equation:
MnCl2 + HOCl + H2O = MnO2 (s) + 3 HCl (see page 4 at http://www.ecs.umass.edu/cee/reckhow/courses/371/371l22/371l... )
as upon adding HCl to both sides, noting that HCl + HOCl = Cl2 + H2O:
MnCl2 + Cl2 + 2 H2O = MnO2 (s) + 4 HCl
which is, of course, the reaction for the generation of Chlorine written in reverse. My point, the reaction is reversible.
Now, instead of adding HCl to each side, lets add FeS2 to each side:
MnCl2 + HOCl + FeS2 + H2O = MnO2 (s) + FeS2 + 3 HCl
Now, the author in the reference cited above claims dissolution for the right side of this equation. But, this implies that MnO2 and even FeS2
(generally a hard act) dissolves in a solution of MnCl2 and HOCl.
In fact, there appears to be a commercial process for the recovery of Gold contained in Iron pyrite based on chlorination (Chlorine or Hypochlorous
acid and a chloride). See page 141 at http://books.google.com/books?id=QeDTeUalP0IC&pg=PA141&a...
Some other references that may be of interest:
"Kinetics and mechanism of MnO2 dissolution in H2SO4 in the presence of pyrite" in Journal of Applied Electrochemistry, February 1999, Volume 29,
Issue 2, pp 191-200.
"Oxidation of FeS2 and FeS by MnO2 in Marine Sediments" by Axel Schippers & Bo Barker Jørgensen at Max Planck Institute, for Marine
Microbiology, Celsiusstrasse, Germany.
"Electrochemical phenomena in MnO2–FeS2 leaching in dilute HCl. part 3: manganese dissolution from indian ocean nodules", published in Canadian
metallurgical quarterly, 1998.
"Biogeochemistry of pyrite and iron sulfide oxidation in marine sediments", published in Geochimica et Cosmochimica Acta, Vol. 66, No. 1, pp.
85–92, 2002.
"Electro-generative mechanism for simultaneous leaching of pyrite and MnO2 in presence of A. ferrooxidans", link: http://www.ysxbcn.com/down/upfile/soft/200856/20085621187488...
"Galvanic interaction between sulfide minerals and pyrolusite", published in Journal of Solid State Electrochemistry, March 2000, Volume 4, Issue 4,
pp 189-198
|
|
|
ScienceSquirrel
International Hazard
Posts: 1863
Registered: 18-6-2008
Location: Brittany
Member Is Offline
Mood: Dogs are pets but cats are little furry humans with four feet and self determination!
|
|
Chemical equations are not mathematical equations
v = u + at
and;
u = v - at
But chemical equations do not obey the same rules.
For instance the equilibrium reaction between calcium oxide and carbon dioxide is dependent on temperature.
At room temperature and up to several hundred degrees the reaction favours calcium carbonate, as it gets hotter, the compound begins to disassociate
until eventually carbon dioxide is driven off as a gas and we are left with calcium oxide.
Calcium oxide will react very slowly with carbon dioxide at room temperature.
This is an equilibrium but it is a slow and temperature dependent one.
Please stop 'adding HCl to both sides', and other pseudomathematical operations, they are in most cases, nonsense.
|
|
|
Boffis
International Hazard
Posts: 1867
Registered: 1-5-2011
Member Is Offline
Mood: No Mood
|
|
The best chemical for the dissolution of MnO2 are Sodium metabisulphite, any weak acid + H2O2, or ascorbic acid.
I use the last frequently to remove MnO2 from delicate minerals such as calcite and aurichalcite
|
|
|
Fantasma4500
International Hazard
Posts: 1681
Registered: 12-12-2012
Location: Dysrope (aka europe)
Member Is Offline
Mood: dangerously practical
|
|
i got approx 5L H2O2 12% with oleic acid added to it (stabilizer?)
i once realised that after i poured it together with abit of MnO2 that the MnO2 got more brownish, this was not what i expected to see, as i have been
trying to destroy MnO2 with oxalic acid and 98% H2SO4
also after having a beaker standing around with 37% HCl and MnO2 for several months time i now have a yellow tinted solution and a brown slurry
manganese chemistry is confusing and extremely messy, please dont handle MnO2 anywhere you are not prepared to destroy the top layer of with sandpaper
|
|
|
ThoughtsIControl
Hazard to Self
Posts: 50
Registered: 13-10-2019
Location: Proxima Centauri
Member Is Offline
Mood: Yin over yang
|
|
"manganese chemistry is confusing and extremely messy, please dont handle MnO2 anywhere you are not prepared to destroy the top layer of with
sandpaper"
I definitely agree with you on the messy part! After jarring mine out of a battery for several minutes, it was a pain to keep my workspace clean.
|
|
|
mackolol
Hazard to Others
Posts: 459
Registered: 26-10-2017
Member Is Offline
Mood: Funky
|
|
If you don't want to mess with strong acids, solution of oxalic acid is very good for removing MnO2 stains
|
|
|
j_sum1
Administrator
Posts: 6320
Registered: 4-10-2014
Location: At home
Member Is Offline
Mood: Most of the ducks are in a row
|
|
Quote: Originally posted by ThoughtsIControl  | "manganese chemistry is confusing and extremely messy, please dont handle MnO2 anywhere you are not prepared to destroy the top layer of with
sandpaper"
I definitely agree with you on the messy part! After jarring mine out of a battery for several minutes, it was a pain to keep my workspace clean.
|
Remember that battery paste is about 30% graphite. That adds a lot to the mess.
It is not clear from the OP (many years ago) whether the goal is to clean up or to get Mn in solution.
The answer to your problem however might be gloves, newspaper, and being tidy.
|
|
|
chornedsnorkack
National Hazard
Posts: 563
Registered: 16-2-2012
Member Is Offline
Mood: No Mood
|
|
Best solvent for MnO2
Which acid is most efficient in dissolving MnO2 precipitate residues?
Strong reducing acids:
H2SO3 could give MnSO4.
The problem here is that many sulphites are poorly soluble. You could just get MnSO3 precipitate instead.
H2C2O4
Same issue. Manganese oxalate can be itself poorly soluble.
HCl? But the problem is that it is weak reducer. Difficult to force the reaction through.
Should it be better to clean MnO2 with HI instead? Much stronger reducer than HCl. MnI2 is fairly soluble. And while
I2 is poorly soluble in water, it dissolves much better in excess HI...
|
|
|
mackolol
Hazard to Others
Posts: 459
Registered: 26-10-2017
Member Is Offline
Mood: Funky
|
|
I don't really know what's the point, are you trying to get rid of MnO2 stains or you just plan to clean aparature from it in future? HCl and oxalic
acid are enough to clean MnO2 residue without problems. HCl is a bit better than oxalic but I've tested both and they do the job. Hot HCl is the best.
There is no need to use expensive and rather useful HI.
[Edited on 20-5-2020 by mackolol]
|
|
|
j_sum1
|
Threads Merged
20-5-2020 at 01:10 |
Bedlasky
International Hazard
Posts: 1239
Registered: 15-4-2019
Location: Period 5, group 6
Member Is Online
Mood: Volatile
|
|
When you work in acidic solution, there isn't any precipitation of MnSO3 or MnC2O4.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
