draculic acid69
International Hazard
Posts: 1371
Registered: 2-8-2018
Member Is Offline
|
|
Question about h2s and phosphine
I read somewhere that hydrogen sulphide bubbled thru h2o2 results in elemental sulphur but upon googling this it seems this isn't right but so2 turns
it into elemental sulphur so would phosphine bubbled thru so2 solution make elemental p4 or would the peroxide turn ph3 into p4. Also is the peroxide
thing wrong or not?
|
|
Ubya
International Hazard
Posts: 1247
Registered: 23-11-2017
Location: Rome-Italy
Member Is Offline
Mood: I'm a maddo scientisto!!!
|
|
SO2 in water makes H2SO3, H2O2 oxidises it to sulphuric acid, no elemental sulphur. on the other hand H2S+SO2 makes elemental sulphur, so maybe
phosphine with phosphorus pentoxide?
---------------------------------------------------------------------
feel free to correct my grammar, or any mistakes i make
---------------------------------------------------------------------
|
|
woelen
Super Administrator
Posts: 8001
Registered: 20-8-2005
Location: Netherlands
Member Is Offline
Mood: interested
|
|
Quote: Originally posted by draculic acid69 | I read somewhere that hydrogen sulphide bubbled thru h2o2 results in elemental sulphur but upon googling this it seems this isn't right but so2 turns
it into elemental sulphur so would phosphine bubbled thru so2 solution make elemental p4 or would the peroxide turn ph3 into p4. Also is the peroxide
thing wrong or not?
|
When writing posts, please use capital letters where appropriate. Especially in formulas, so use PH3 instead of ph3 and so on.
PH3 is not as easily oxidized to elemental phosphorus as H2S is to elemental sulphur.
If PH3 is oxidized, then it easily is oxidized to phosphorus in oxidation state +3 or phosphorus in oxidation state +5. Bubbling it through a solution
of phosphoric acid will not lead to a reaction. Phosphoric acid only is acidic, it has no oxidizing properties. I also do not expect any reaction
between dissolved SO2 and PH3.
I have done quite a few experiments with PH3 and I saw, that if I burn PH3 and there is insufficient oxygen, then you get brown and yellow stuff,
which settles on the vessel in which the PH3 is. This most likely is a complicated mix of phosphorus-compounds in lower than +3 oxidation state, but
it certainly is not pure phosphorus.
I noticed that phosphorus in low oxidation state (<=0) does not tend to react cleanly when there is shortage of oxidizer. You get all kinds of
brown, red/brown or yellowish compounds, which do not dissolve in water, but which can fairly easily be dissolved in bleach or chlorine-water.
Probably phosphorus forms sub-oxides of indeterminate composition.
|
|
unionised
International Hazard
Posts: 5114
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
If I had phosphine and I wanted phosphorus, I'd just heat it.
|
|
Herr Haber
International Hazard
Posts: 1236
Registered: 29-1-2016
Member Is Offline
Mood: No Mood
|
|
If I had phosphorus and I wanted phosphine I'd just heat it (with dilute acid)
Or: How I inadvertantly discovered the smell of phosphine...
|
|
chornedsnorkack
National Hazard
Posts: 558
Registered: 16-2-2012
Member Is Offline
Mood: No Mood
|
|
Phosphine is not arsine.
I am not sure PH3 would be unreactive with SO2
From Pourbaix diagram of sulphur, SO2 has no stability field. It is always unstable to dismutation to sulphates and S (in acid conditions)
or HS- (in base). However, sulphites and sulphurous acid are reasonably long-lived. Meaning they are also stronger oxidants than sulphates
and dilute sulphuric acid.
I see that Pourbaix diagrams of phosphorus diverge from each other. The species proposed for strongly reducing conditions include
H3PO3, H3PO2, P4 and PH3.
P4 is known to dismute in both acidic conditions (as reported by Herr Haber and others) and basic conditions. Of course, since
P4 exists outside its stability field, it can also be produced outside its stability field.
A weak oxidant reacting with excess of PH3 might be selective for reasons of mechanism, and produce mainly P4, not
H3PO4, H3PO3, H3PO2 or suboxides. But I do not know which oxidants might have such
selectivity.
|
|
morganbw
National Hazard
Posts: 561
Registered: 23-11-2014
Member Is Offline
Mood: No Mood
|
|
wow @chorenedsnorkack
I may need to back up and read all of your posts.
|
|
clearly_not_atara
International Hazard
Posts: 2747
Registered: 3-11-2013
Member Is Offline
Mood: Big
|
|
Quote: | A weak oxidant reacting with excess of PH3 might be selective for reasons of mechanism, and produce mainly P4, not H3PO4, H3PO3, H3PO2 or suboxides.
But I do not know which oxidants might have such selectivity. |
Mechanism schmechanism. If you want to avoid forming phosphoric acids, just don't let there be any oxygen present. Actually the first thing that comes
to mind is PBr3. Perhaps you can oxidize some phosphine with bromine, and then comproportionate PBr3 and PH3 in the presence of a catalytic amine? Eg:
2 PBr3 + 2 PH3 + 6 NEt3 >> 6 NEt3HBr + 3 P4
However, to me the main problem is I just don't want to deal with any phosphine whatsoever ;D
EDIT: With careful stoichiometry:
4 PH3 + 6 Br2 + 12 NEt3 >> P4 + 12 NEt3HBr???
[Edited on 23-12-2018 by clearly_not_atara]
|
|