Preparation of 3-Indoleacetaldehyde from Tryptophan
To 100 ml. of distilled water were added 15 ml. of 10% NaOH solution and 3.0 g. of DL-tryptophan. After the tryptophan was completely dissolved, 4 N
HCl was added until tryptophan crystals just started to separate at a pH near 8.5. The solution was diluted immediately with 1200 ml. of distilled
water in a 4000-ml. Erlenmeyer flask. To this solution was added 700 ml. benzene followed by 200 ml. of 0.52% sodium hypochlorite solution made by
mixing 1 part Chlorox with 9 parts water. The flask and contents were shaken with a swirling motion immediately after the addition of the hypochlorite
and during the entire duration of the experiment so that the aldehyde was taken up in the benzene as soon as it was produced. Care was taken to avoid
an excess of hypochlorite which produced brown-colored products. This also happened if dilute solutions were not used. The flask was immersed in a hot
water bath, and the temperature of the contents was raised to 50 degrees C. over a period of 20 min. The temperature was held between 50 and 51
degrees C. for 15 min. more. The benzene layer became yellow in color and later turned orange. The benzene was separated from the aqueous phase with a
separatory funnel while still warm.
The benzene solution was concentrated to 65 ml. in a large evaporating dish placed in a swift current of air in a fume hood. Slight heat was supplied
with a warm water bath at 40-50 degrees C. The resulting benzene solution was shaken with 50 ml. of saturated sodium bisulfate solution in a closed
wide-mouth bottle. Crystals of the IAc.NaHSO3 formed immediately and were filtered almost dry by suction.. The product was resuspended twice and
shaken vigorously in 95% ethanol and filtered each time. The crystals were washed again with absolute alcohol and finally with ether. After drying at
room temperature, the yield was 4.06 g. of white crystalline material. The yield was 90% of theoretical based on the amount of tryptophan used. Most
of the IAc.NaHSO3 was dissolved in a small amount of water making a saturated solution. The solution was filtered, and the IAc.NaHSO3 was
recrystallized by adding absolute ethanol to a final concentration of 90% ethanol, yielding 2.5 g. of recrystallized product.
To obtain the free aldehyde, 200 mg. of the IAc.NaHSO3 was dissolved in 8 ml. water. A few drops of a saturated solution of Na2CO3 was added until the
solution turned slightly turbid. After standing a few minutes, the free aldehyde was extracted by shaking the solution with three portions of
peroxide-free ether. After evaporation of the ether and drying at reduced pressure, 82 mg. IAc was obtained as a colorless sirupy liquid.
|
