Rich_Insane - 23-1-2013 at 21:39
Hey everyone:
I have a product which was reacted in a little too much xylene, and it is slightly soluble in xylene, so there is likely a lot of product dissolved in
the solvent. Now, I know I have to boil off xylene, but I am afraid to do so. I cannot go outdoors to do this because it is very cold (around the
freezing point of water) and I am using a cheap cooking stove as a hotplate. I have qualms about boiling a volatile, highly flammable solvent inside
my house -- I also get a lot of lung irritation from the vapor at STP , let alone a cloud of vapor from boiling solvent.
Is xylene volatile enough to evaporate rapidly in air? Can I just boil it down in small (~20 ml --> 10 ml with about 160 ml total, final volume
intended at 80 ml) aliquots? Suggestions?
Sedit - 23-1-2013 at 21:46
Why not make a getto distillation of sorts to either recover your Xylene or at the very least dispose of your vapors.
Rich_Insane - 23-1-2013 at 22:02
What do you reccomend? I have a distillation apparatus, but no ring-stand, no thermometer adapter and no pump to cycle water through the jacket.
Tsjerk - 24-1-2013 at 05:13
For the pump part, you can hook it up on your water supply directly. It sounds like a waste of water, but if you hook up the water supply on the
bottom you only have to run a very little amount of water to keep your condenser cool, If you really don't want to waste water you can probably turn
it on for a couple of seconds once in a while, depending on the rate you're distilling with and the size of your condenser.
A thermometer isn't necessary in your case as you just want to boil down, just put something in the hole to close it.
A ring-stand you should just buy.
smaerd - 24-1-2013 at 06:24
Xylene will evaporate in air no so much in the winter time. Not a good idea to evaporate the stuff inside your house.
Maybe boiling it off through a plug of dry activated carbon could help to remove some of the vapors. Ultimately though you should really invest in a
distillation apparatus + ring-stand & clamps which recycles the pump water(pond pump).
Might be able to do a short path-distillation(flask, thermometer adapter, vacuum take off, flask) with no condenser(depending on how much solvent you
want to boil of and how well your compound can handle heat), run a hose from the vacuum take-off out a window or something.