You can make your own very easily and cheap.
You will need following things:
1) wooden board that you will cut on your own or pre-cut
2) silicone from hardware store
3) Floor tiles - enough to cover all the internal surface
4) Glue and other things that you need to glue tiles
Put some silicone on the edges of the hood which will have contact with the wooden board.
Place the hood on the wood.
Place floor tiles on the internal part of the wood board. Glue it properly, do not forget about proper grouts
When it's done, put some silicon on the internal edges of the hood, just to make it sealed (there is nothing funny when you have a toxic spill in
place you thought it will contain it).
Et voila!
Yo have your bottom surface made cheaply. You don't need to worry about chemical compatibility, there is not so much of substances which can damage
them. Tiles are hard, they can take some kinetic energy without breaking. They are very, very easy to clean.
If you want to have there a sink then just buy it, make a hole in the place where you want to have it, attach to receiving system and done. As a tap I
recommend to use a lab grade tap as they have very good shape which makes easier things like cleaning. It is better to have valves on the outside of
hood but you can have it also inside. Just put it close enough to be able to use it without sticking your head to the hood.
A good improvement of the design will be a sill that will prevent any spills from getting outside via the front. Can be also done relatively simple.
It is very easy to do, if you haven't tools needed for that you can order pre-made wooden surface and rent the tile cutting machine. It will take you
maybe 2 days, I assume that you will wait for the stuff that you ordered longer than it will take to make the basic type of surface.
|
