Panache - 24-3-2021 at 17:29
Looks well made enough that im thinking its an extremely 'project-specfic' piece of kit that i will never know what's its for.
In short the readout is spin speed/motor power for the two round spinning bits
The gas torch is adjustable however appears to be designed to run across the top of the spinny bits.
Any ideas?
Deathunter88 - 24-3-2021 at 22:04
Brass cartridge case neck annealer?
I should elaborate, it's used in reloading to anneal the necks of brass catridge cases after resizing to ensure consistent neck tension when a new
bullet is seated.
[Edited on 25-3-2021 by Deathunter88]
Dr.Bob - 25-3-2021 at 06:23
Looks similar to a glass ampule sealer as well, most have a carousel for ampules, and then spin the ampule as it goes into the torch. The ampule
sealer rarely work wells in my experience. Hopefully the annealer does a better job.