chemrox
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2961
Registered: 18-1-2007
Location: UTM
Member Is Offline
Mood: LaGrangian
|
|
straight walled beakers
I'm looking for straight walled beakers. These are really useful for boiling the product out of RB and evap flasks. The lip allows too much solvent
to escape.
"When you let the dumbasses vote you end up with populism followed by autocracy and getting back is a bitch." Plato (sort of)
|
|
Dr.Bob
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2690
Registered: 26-1-2011
Location: USA - NC
Member Is Offline
Mood: No Mood
|
|
Not sure if you just want a beaker without a pour spout or more of a tall crystallizing dish. I use crystallizing dishes for this type of task, but
the are wider than they are tall.
There are also TLC chambers made that are just simple cylinders, typically about 60 mm diameter by 110-120 mm height. I have a few left. Not sure
if they are all borosilicate glass, but at least some of them are made of that. I still would not heat them too strongly. Here are two examples:
http://www.capitolscientific.com/Wheaton-276850-Mini-TLC-Dev... (photo looks like a 60 x 110 mm one to me, which is what I have, but I have seen
the taller ones as well).
http://www.carlroth.com/catalogue/catalogue.do;jsessionid=BC...
[Edited on 16-11-2013 by Dr.Bob]
|
|