Wizzard
Hazard to Others
Posts: 337
Registered: 22-3-2010
Member Is Offline
Mood: No Mood
|
|
Sulfur and Toluene: Growing large rhombohedral crystals.
Just a quick write up- I got many PMs and saw people asking about my sulfur crystals.
Pouring about 1L of cold toluene in a large vertical graduated cylinder (almost to the top), then added about 50-100g of fairly pure (at least 99%)
sulfur flour. I sealed the top of the vessel with 2 layers of aluminum foil (the liquid must not contact the aluminum- Sulfur will corrode the
aluminum).
I then insulated the bottom 2/3rds of the vessel, and put it on a hot plate. I attempted to use a heat sink on the top of the vessel, but it was not
necessary. Airflow over the top of the vessel was created with a fan- The top of the vessel must be cooled.
Then, place the vessel on a hot plate, and tilt the vessel and hot plate a few degrees- This will assist convection and internal flow.
The hot plate was set for 50*C, and left for a few days. Over this time, convection occurred, and hot saturated toluene precipitated sulfur once it
cooled.
The hottest liquid must not exceed 46*C, otherwise thin, prismatic crystals will have a chance of forming. The lower the 'hot' temperature, the slower
the crystals will form, but the clearer they will be (most crystals will have inclusions of toluene, disrupting the crystal structure).
Large, single crystals are VERY possible, I just wanted super-pure sulfur (achieved by then heating the sulfur below it's melting point, as a powder,
to remove all toluene). Lower temperatures, more convection, and purer ingredients will help.
 
Added quick note: Crystals shown here grew over a few days, at 40*C 'hot' in a 20*C room. The layer of white-ish crud at the crystal level is the
floated particulate impurity in the sulfur flour, the junk at the bottom is the same (or maybe other other) impurity, once the sulfur has been pulled
into solution and removed from that area.
[Edited on 7-24-2012 by Wizzard]
[Edited on 7-25-2012 by Wizzard]
|
|
|
smaerd
International Hazard
Posts: 1262
Registered: 23-1-2010
Member Is Offline
Mood: hmm...
|
|
Very nice! This was something I always wanted to try.
|
|
|
Sublimatus
Hazard to Others
Posts: 108
Registered: 8-6-2011
Member Is Offline
Mood: No Mood
|
|
Beautiful.
I was going to U2U you about this. Thanks for doing a write-up.
|
|
|
blogfast25
International Hazard
Posts: 10562
Registered: 3-2-2008
Location: Neverland
Member Is Offline
Mood: No Mood
|
|
Nice work, Wizz.
|
|
|
Wizzard
Hazard to Others
Posts: 337
Registered: 22-3-2010
Member Is Offline
Mood: No Mood
|
|
Thanks, guys. I'll post some more pics, including what grows at higher temperatures.
The results present were formed at warm/cool, I've done hot/cool (crystals are strange, form at edges like Bismuth) and cool/cold.... 30*C 'hot' with
a 15*C cold air works wonderfully, but SLOWLY!
|
|
|
kuro96inlaila
Hazard to Self
Posts: 96
Registered: 21-6-2010
Location: Malaysia
Member Is Offline
Mood: Quietly thinking
|
|
Thanks for the method Wizzard!
|
|
|
Zan Divine
Hazard to Others
Posts: 170
Registered: 3-12-2011
Location: New York
Member Is Offline
Mood: Wishing all the worst that life has to offer to that SOB Wayne Lapierre
|
|
Thanks for this interesting contribution!
He who makes a beast of himself gets rid of some of the pain of being a man. --HST
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
