bearbot22
Harmless
Posts: 23
Registered: 10-4-2018
Member Is Offline
Mood: No Mood
|
|
Ball Mill From A Cordless Drill
Just converted my Cordless Drill into a Ball Mill / Tumbling Mill with no costs.
The Childproof cap does the trick because it turns free counter-clockwise. The Upper part of the cap sticks firmly in the hole while the lower part
with the bottle can rotate.
The only tricky part was sticking the Screw through the hole in the bottle-bottom from the inside. I managed it with a string and magnet.
Just make sure you set the Drill to a counter-clockwise operation.
For permanent operation, use a wire to pull the trigger. Wind slowly until speed is right.
With a square bottle it acts like a tumbling mill.
OK, it has a limited capacity and a run will only last as long as your battery does (45min in my case) but Hey - it’s working really well and made
in a few minutes.
|
|
|
knowledgevschaos
Harmless
Posts: 41
Registered: 9-8-2023
Location: Sci-Hub and the hardware store
Member Is Offline
Mood: Hungry for information
|
|
This seems like a great project, but will the cap gradually wear out?
Know thy incompatibilities
|
|
|
Conure
Hazard to Self
Posts: 53
Registered: 6-2-2023
Location: Schweden
Member Is Offline
|
|
What are you planning to mill? Most materials that are safe to mill can be purchased.
Fire is good. Fire is life.
|
|
|
bearbot22
Harmless
Posts: 23
Registered: 10-4-2018
Member Is Offline
Mood: No Mood
|
|
I don't think the cap will wear out as long as you keep everything aligned and the screw is centered. Anyway it could be replaced easily.
child resistant cap, parts separated
I used this mill for about 4h until now with no signs of wear off.
I'm grinding ion exchange resin beads using steel balls.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
