theAngryLittleBunny
Hazard to Others
Posts: 130
Registered: 7-3-2017
Location: Austria
Member Is Offline
Mood: No Mood
|
|
Can Platinum be used as a hydrogenation catalyst?
As far as I know, palladium is usually used as a hydrogenation catalyst, mostly for alkenes. However I decided to order platinum instead because
palladium is just so expensive and I think platinum is a much cooler element then palladium.
However I would like to do hydrogenations of alkenes and maybe some other reductions with hydrogen and would like to know if platinum can do that as
well if I turn it into platinum black or platinum on carbon, even though palladium may still be superior. Or should I have posted this question before
ordering platinum for 130€? lol.
I read online about platinum being used for some kind of hydrogenation reaction and assumed it would just be a slightly inferior option to palladium,
but still useful. Any help would be appreciated.
|
|
|
Bedlasky
International Hazard
Posts: 1239
Registered: 15-4-2019
Location: Period 5, group 6
Member Is Offline
Mood: Volatile
|
|
Metals from nickel group (Ni, Pd, Pt) are often used as hydrogenation catalyst. Nickel would be very cheap hydrogenation catalyst. But I don't know if
these metals are always interchangable or just in some cases.
|
|
|
crow6283
Hazard to Self
Posts: 60
Registered: 14-1-2018
Member Is Offline
Mood: No Mood
|
|
PtO2 can be used to reduce double bonds as effectively as Pd/C. PtO2 can be prepared fairly easy for the home chemist, I believe some people have
even done this on YouTube!
|
|
|
leau
Hazard to Others
Posts: 122
Registered: 3-12-2021
Member Is Offline
|
|
Using the search engine here could have found:
https://www.sciencemadness.org/whisper/viewthread.php?tid=41...
and then employing Scholar:
http://library.lol/main/D65779753A27B4F0ED758B804D6457CB
which is attached for those who can't be bothered  The end results from the effort
applied 
Attachment: Paul Rylander (Auth.) - Catalytic Hydrogenation Over Platinum Metals-Elsevier Science (1967).pdf (7.3MB)
This file has been downloaded 443 times
|
|
|
draculic acid69
International Hazard
Posts: 1371
Registered: 2-8-2018
Member Is Offline
|
|
Quote: Originally posted by theAngryLittleBunny  | As far as I know, palladium is usually used as a hydrogenation catalyst, mostly for alkenes. However I decided to order platinum instead because
palladium is just so expensive and I think platinum is a much cooler element then palladium.
However I would like to do hydrogenations of alkenes and maybe some other reductions with hydrogen and would like to know if platinum can do that as
well if I turn it into platinum black or platinum on carbon, even though palladium may still be superior. Or should I have posted this question before
ordering platinum for 130€? lol.
I read online about platinum being used for some kind of hydrogenation reaction and assumed it would just be a slightly inferior option to palladium,
but still useful. Any help would be appreciated. |
Yes U definitely should have posted before paying that much.
I'm a supplier of platinum group metals and have better prices than 99%
of other sellers. How much metal are U getting for that much money?
[Edited on 30-1-2022 by draculic acid69]
|
|
|
draculic acid69
International Hazard
Posts: 1371
Registered: 2-8-2018
Member Is Offline
|
|
| Quote: Originally posted by Bedlasky | | Metals from nickel group (Ni, Pd, Pt) are often used as hydrogenation catalyst. Nickel would be very cheap hydrogenation catalyst. But I don't know if
these metals are always interchangable or just in some cases. |
I think nickel requires much higher pressures and temperatures
than platinum or palladium. the difference between maintaining
a rxn at 30psi while stirring/rocking/heating all at once compared to
300psi is a major difference.
|
|
|
zed
International Hazard
Posts: 2283
Registered: 6-9-2008
Location: Great State of Jefferson, City of Portland
Member Is Offline
Mood: Semi-repentant Sith Lord
|
|
Oh, an easy prep is dissolving the Platinum in Aqua Regia to produce Chloroplatinic Acid.
And then reducing the Chloroplatinic Acid to Platinum Black with Sodium Borohydride in Ethanol.
It produces a very active Catalyst.
Use the search engine. We have discussed this many times.
A little while back, I bought a Platinum coin for this purpose.
Very pure. Reasonable price. Just a little over Spot price.
Ebay.
[Edited on 30-1-2022 by zed]
|
|
|
draculic acid69
International Hazard
Posts: 1371
Registered: 2-8-2018
Member Is Offline
|
|
| Quote: Originally posted by zed | Oh, an easy prep is dissolving the Platinum in Aqua Regia to produce Chloroplatinic Acid.
And then reducing the Chloroplatinic Acid to Platinum Black with Sodium Borohydride in Ethanol.
It produces a very active Catalyst.
Use the search engine. We have discussed this many times.
A little while back, I bought a Platinum coin for this purpose.
Very pure. Reasonable price. Just a little over Spot price.
Ebay.
[Edited on 30-1-2022 by zed] |
I can usually be cheaper than eBay.
I have very competitive prices.
|
|
|
Dr.Bob
International Hazard
Posts: 2732
Registered: 26-1-2011
Location: USA - NC
Member Is Offline
Mood: No Mood
|
|
| Quote: Originally posted by draculic acid69 | | Quote: Originally posted by Bedlasky | | Metals from nickel group (Ni, Pd, Pt) are often used as hydrogenation catalyst. Nickel would be very cheap hydrogenation catalyst. But I don't know if
these metals are always interchangable or just in some cases. |
I think nickel requires much higher pressures and temperatures
than platinum or palladium. the difference between maintaining
a rxn at 30psi while stirring/rocking/heating all at once compared to
300psi is a major difference. |
For some reactions Raney Nickel in ethanol works great at very low pressures, like nitro to amine, and some other easy reductions. it can also be
used for transfer type reductions, like with hydrazine, which will provide hydrogen in the presence of Raney nickel. I think many other reducing
agents can work as well. It comes in water and often just a bit of slurry from a Pasteur pipette will work for a reaction. Much easier than Pd/C
for nitro reductions, and can be selective as well.
|
|
|
Fantasma4500
International Hazard
Posts: 1681
Registered: 12-12-2012
Location: Dysrope (aka europe)
Member Is Offline
Mood: dangerously practical
|
|
aha just dissolving platinum in NOCl? my advice is that you divide into very small pieces, perhaps even grind it down on sandpaper
took me a week on/off with constant boiling and constant addition of acid to dissolve one single gram of platinum, NurdRage also expressed some type
of despair towards this dissolution project
once you have it dissolved it can simply be thermally decomposed, you may test that its indeed platinum with hydrogen peroxide, it catalyses its
decomposition
|
|
|
SWIM
National Hazard
Posts: 970
Registered: 3-9-2017
Member Is Offline
|
|
I think the Borohydride route is supposed to give a somewhat more active catalyst.
I also think this is the spoon-feediest question I've seen posted about hydrogenation catalysts.
Not knowing platinum can be used for a hydrogenation catalyst is like not knowing water can be used as a polar solvent.
|
|
|
AvBaeyer
National Hazard
Posts: 651
Registered: 25-2-2014
Location: CA
Member Is Offline
Mood: No Mood
|
|
Well said, SWIM.
AvB
|
|
|
BromicAcid
International Hazard
Posts: 3245
Registered: 13-7-2003
Location: Wisconsin
Member Is Offline
Mood: Rock n' Roll
|
|
It's also interesting to think how finances figure into research, for years palladium was the cheaper of the platinum/palladium pairing which probably
drove some research budgets but things have been inverted now for the last couple years.
|
|
|
zed
International Hazard
Posts: 2283
Registered: 6-9-2008
Location: Great State of Jefferson, City of Portland
Member Is Offline
Mood: Semi-repentant Sith Lord
|
|
In my youth, Platinum was about $300/ Oz.. Palladium was $30-$40/ per Oz..
Gold could be purchased for about $125/Oz as Krugerrands.
The price of Palladium has gone wild.
|
|
|
clearly_not_atara
International Hazard
Posts: 2787
Registered: 3-11-2013
Member Is Offline
Mood: Big
|
|
Pd is just as rare as the others, but there was an oversupply following the collapse of the Soviet Union and the new Russian government basically
plundering stockpiles to pay for graft
|
|
|
SWIM
National Hazard
Posts: 970
Registered: 3-9-2017
Member Is Offline
|
|
| Quote: Originally posted by clearly_not_atara | | Pd is just as rare as the others, but there was an oversupply following the collapse of the Soviet Union and the new Russian government basically
plundering stockpiles to pay for graft |
I believe Zed is older than that
He's talking prices not long after Bretton Woods , I think. (early or mid 70s)
I wasn't following catalytic hydrogenation metal prices much back then, but I was in the 1980s, and palladium was much cheaper than gold or platinum
in the 80s.
I started following precious metal prices when the Hunt Brothers tried to corner the silver market.
I Got lucky and sold my silver stash at something like $30/oz on the way up.(It peaked near $50 before the crash) I had a bunch from coin collecting
as a little kid. Back then you could get $20 worth of dimes at the bank and there'd be a few silver ones in there as we made silver coins up until
1964 and some were still circulating. I did this many times and had a bunch of them when the Hunt brothers did their thing around 1980.
After that windfall I watched precious metals for years, but never made profit like that again (except a big old ingot I got at a garage sale in the
90s. Silver again, but so damned tarnished the seller thought it was some cheap mystery metal. And there was a wine bottle full of mercury that I
eventually did okay on too.)
Anyway I followed the really precious stuff too. Wanted to try the catalytic converter thing in the early 90s, but never actually did it. Didn't know
that much chemistry yet.
I also wanted to make fake Krugerands with tungsten inside them, but that was way out of my league and The one real connection I'd had as a teen was
dead by then.
I haven't checked my recollections against the interwebs, but I'm pretty damn confident I'm right about those price trends.
Edit:
Some of this might not sound like me to some of you, but there were some real grease-ball thieving fucks in my family and it can kinda rub off on you.
When my Nonno (My Italian grandpa, the other one was good as gold) got older and less tactful he sometimes told stories that freaked people out. I
remember one birthday party in his 80s where he gleefully told a story about a long, brutal fight which ended with the line, "So I dumped him in a
drainage ditch and they never found the body." He said this with a grin and a chuckle.
I never hurt anybody and wasn't a robber.
Except the 'bank job'. Not what you're thinking though. I helped Nonnu and my uncle (a real fuckwit piece of shit) steal part of a bank. About 2000
pounds. Not in money, in weight.
We actually broke into the construction site where a bank was being renovated and stole about a ton of bricks and decorative stone-work one Sunday.
So I was a bank robber maybe? No, really just a bank thief. A weird minor crime by comparison but still grand theft if they caught us. But I was only
15 then. They brought me along because I was stronger than most adults already and my accomplices were one in his 70s and the other was about as tough
physically as the Pillsbury doughboy.
Seemed like fun at the time but it could've ruined my life I guess.
Sounds like the kind of story a clever guy like me could make up for clout, but that's not what I call clout.
But if you any of you guys/gals are skeptical I'll still settle for credit for making up a good lie.
You all are the first people outside my family I have ever told about this. They say confession is good for the soul, but I don't have one.
I don't think any of you have one either, but even if I'm wrong about you I know I don't have one. But I also know you don't need one to be good.
Good enough, at least.
Edited to remove political reference.
I actually kinda like her personally and she was pretty shocked by that story and obviously wished she wasn't there. What was she supposed to do, call
the cops about an unsubstantiated 60 year old murder confession? I could've done that too, but I didn't either.
Asked a cop I knew about this sort of thing years later. He said it's not the kind of thing that would even get investigated as there was no proof of
a crime other than the story. Probably wasn't even a missing persons report, and if there was the records were long gone by now.
[Edited on 23-4-2022 by SWIM]
[Edited on 23-4-2022 by SWIM]
[Edited on 23-4-2022 by SWIM]
[Edited on 23-4-2022 by SWIM]
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
