Delta-R
Harmless
Posts: 16
Registered: 6-5-2018
Member Is Offline
|
|
Cleaning Nitric Acid Stains from Skin
So the general consensus from everything I’ve ever read has been that it’s impossible to remove Nitric acid stains from skin and you just need to
wait for new skin to replace it. Well I’ve done a bit of experimenting and have found that’s not quite the case. Now first off, the best plan is
to wear good gloves and not have get any nitric on you in the first place but obviously accidents happen. This probably isn’t great for your skin so
I don’t recommend doing it unless you have a reason to and definitely use some moisturizer afterwards. But with that out of the way:
To start, make a concentrated solution of sodium hydroxide and let it cool. Using a paper towel, apply the NaOH solution to the affected area. You
will notice an instant color change from yellow to deep orange. Leave it on until you can just start to feel a bit of discomfort, then under running
water, use a scotch brite pad to scour the area. The affected skin will begin to flake away leaving clean skin underneath. Depending on the area
affected, and other factors (probably including how oily your skin is), it may require you repeat the process, however it will eventually all come
off, leaving the area feeling a bit dry but otherwise no worse for wear. This works on fingernails as well. A control area that was scoured without
applying the sodium hydroxide solution was left looking a little better but still stained significantly.
I assume the mechanisms involve the NaOH neutralizing the xanthoproteic acid which causes the yellowing, as well as drying out the affected layer of
epithelial cells due to saponification of the oils in the skin allowing them to be more easily sloughed off from mechanical abrasion, as well as
allowing water to better solvate some of the reactants and carry them away, but if anyone has a more nuanced understanding of what’s going on,
definitely share.
|
|
MineMan
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 998
Registered: 29-3-2015
Member Is Offline
Mood: No Mood
|
|
Can you move this to general Chem?
|
|
woelen
|
Thread Moved 28-4-2022 at 23:07 |
woelen
Super Administrator
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 7997
Registered: 20-8-2005
Location: Netherlands
Member Is Offline
Mood: interested
|
|
I moved this to responsible practices, this has not much to do with energetic materials.
I would be very reluctant in trying this. I certainly would not try this on more than a few square cm, and only on less critical places like fingers,
hands, maybe arms or legs. The yellow color may be removed, but what comes in place of that? How will it look like after a few days? Is there a chance
of having residual scars? So, be careful!
|
|
SWIM
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 970
Registered: 3-9-2017
Member Is Offline
|
|
I think this works because concentrated lye dissolves human beings.
You're just stopping the process before completion.
There may be a faster way: The stain is a nitrated organic, so perhaps it could be detonated off with a suitable primer.![:D](./images/smilies/biggrin.gif)
Now there's an energetic materials solution to the problem.
Edit: If the lye solution is warmed to 150C it takes about 3 hours to turn a person into an scummy brown fluid. Certain drug cartels use this
disposal method.
But to be fair, I am pretty sure they were doing this in New Jersey and the Rhode Island /Delaware area first. Like back in the 80s.
Probably not common, but there were stories even Back then.
[Edited on 29-4-2022 by SWIM]
[Edited on 29-4-2022 by SWIM]
[Edited on 30-4-2022 by SWIM]
|
|
RustyShackleford
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 200
Registered: 10-12-2020
Location: Northern Europe
Member Is Offline
|
|
Lye decreases the structural integrity of the skin, scouring pad then is able to remoev a deeper layer of it.
|
|
Texium
Administrator
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 4552
Registered: 11-1-2014
Location: Salt Lake City
Member Is Offline
Mood: PhD candidate!
|
|
Nope. No thanks, I’ll keep the yellow stains for a few days rather than chemically removing my skin.
|
|
Delta-R
Harmless
Posts: 16
Registered: 6-5-2018
Member Is Offline
|
|
Again, I specifically said I wouldn’t recommend doing it regularly or if you don’t need to, and I definitely agree that its probably a bad idea to
try this on any sensitive areas, however if you have a job interview or something where it NEEDS to be removed, this works great on hands, etc. I can
report no ill effects after a week - there was never any redness, pain, discomfort of any kind, no peeling, blistering, etc.… Dryness is really the
only side effect I’ve noticed. Essentially this is a basic chemical peel which is a common dermatological procedure.
Like I said, I would definitely recommend lotion/moisturizer application after this just to rehydrate the skin, and certainly never do this with a
warm or hot solution, make sure it’s cooled off completely to room temperature before attempting, as hot sodium hydroxide is obviously much more
aggressive. But from personal experience, I am confident that this method can be utilized occasionally as needed with complete safety
|
|
Jome
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 154
Registered: 10-6-2004
Location: Soutwest sweden
Member Is Offline
Mood: desiccated
|
|
Only process I know of that could reduce nitro-groups in neutral conditions like that is with sodium dithionite, perhaps try that?
|
|
Amos
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 1406
Registered: 25-3-2014
Location: Yes
Member Is Offline
Mood: No
|
|
Why would you shun your chemist battle scars? They're to be worn with pride! Real talk, doing MORE damage to your skin just to remove evidence of
prior damage is about as inane as it gets. You're defatting your skin by doing this, opening yourself up to infections and definitely causing
irritation. Stick to nonliving materials to run your experiments on.
|
|
SWIM
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 970
Registered: 3-9-2017
Member Is Offline
|
|
If it isn't fuming acid you could always use some gloves.
You explosives guys have it tough by comparison with your high-power nitrating mixtures.
I wonder if there are effective barrier creams for that?
|
|
Triflic Acid
Hazard to Others
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 486
Registered: 27-9-2020
Member Is Offline
Mood: Slowly Oxidizing into Oblivion
|
|
Honestly, it doesn't hurt and doesn't have any negative health effects, so I don't see why you would bother. I got some fuming stuff on my hand and it
didn't even sting. The only downside was people asking, but I just said it was pen-ink
There wasn't a fire, we just had an uncontrolled rapid oxidation event at the power plant.
|
|
Keras
National Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 856
Registered: 20-8-2018
Location: (48, 2)
Member Is Online
|
|
Nitric acid interacts with the keratin present in skin and nails. Just wait until the dead epidermis wears off normally. Regeneration of skin should
be complete within 3 weeks.
|
|