AlbinoMoose308
Harmless
Posts: 4
Registered: 27-1-2015
Location: TN, USA
Member Is Offline
Mood: No Mood
|
|
Copper Pyrophosphate?
I'd like to make some copper pyrophosphate (Cu2P2O7) for electroplating but I don't know how. I've got potassium pyrophosphate. Would a double
replacement be appropriate? I can't seem to find information on the solubility of the copper salt...
Taking all suggestions
thanks 
[Edited on 1-19-2021 by AlbinoMoose308]
Acquiring a lab is difficult when you're dead-set on not spending a penny
Chlorine trifluoride should be officially designated "liquid fire"
|
|
|
Bedlasky
International Hazard
Posts: 1244
Registered: 15-4-2019
Location: Period 5, group 6
Member Is Offline
Mood: Volatile
|
|
Yes, double displacement is possible, but add excess of copper salt. Pyrophosphates are very good ligands for divalent cations, so if you add excess
of pyrophosphate, you get soluble complex.
Another option is thermal decomposition of ammonium copper phosphate (which can be made by precipitation from aqueous solution).
[Edited on 19-1-2021 by Bedlasky]
|
|
|
AlbinoMoose308
Harmless
Posts: 4
Registered: 27-1-2015
Location: TN, USA
Member Is Offline
Mood: No Mood
|
|
Ammonium copper phosphate...
That could be prepared by adding copper oxide to a solution of monoammonium phosphate, right?
Do you think ABC type dry chemical from a fire extinguisher would work for that? (should be ~60% pure, the rest being ammonium sulfate) I happen to
have a few pounds of the stuff handy. I could try that out tomorrow!
[Edited on 1-19-2021 by AlbinoMoose308]
Acquiring a lab is difficult when you're dead-set on not spending a penny
Chlorine trifluoride should be officially designated "liquid fire"
|
|
|
vano
National Hazard
Posts: 661
Registered: 22-3-2019
Location: Georgia
Member Is Offline
|
|
A few years ago I made sodium pyrophosphate from Na2HPO4. As far as I can remember very little pyrophosphate was dissolved in the water, which is very
bad for the exchange reactions. I saw in a Chinese source that copper sulphate and sodium pyrophosphate are obtained, of course it is possible, but it
is difficult when a few grams are dissolved in a liter of water. Copper pyrophosphate has light green colour.
|
|
|
Bezaleel
Hazard to Others
Posts: 444
Registered: 28-2-2009
Member Is Offline
Mood: transitional
|
|
But as copper precipitates the (P2O7)4-, more of the ammonium salt should dissolve, unless the formed Cu2P2O7 sticks to the ammonium salt, preventing
it to dissolve. Some agitation might help?
|
|
|
Bedlasky
International Hazard
Posts: 1244
Registered: 15-4-2019
Location: Period 5, group 6
Member Is Offline
Mood: Volatile
|
|
Bazaleel: Where do you see ammonium ions in the reaction between potassium (or sodium) pyrophosphate and copper sulfate?
Vano: I didn't have issues with dissolving pyrophosphate. But I did it just once in the test tube when I made Mn(III)-pyrophosphate complex.
|
|
|
vano
National Hazard
Posts: 661
Registered: 22-3-2019
Location: Georgia
Member Is Offline
|
|
Tetrasodium pyrophosphate Solubility in water. From Wikipedia.
2.61 g/100 mL (0 °C)
6.7 g/100 mL (25 °C)
42.2 g/100 mL (100 °C)
This compound dissolves quite a large amount in boiling water. It's enough. However it dissolves poorly in warm water. I meant that.
Did you mean manganese ammonium pyrophosphate? This is a different reaction. Here manganese goes from 2 to 3. Copper pyrophosphate is made by the
exchange reaction. I made pyrophosphate from Mn oxide, phosphoric acid and ammonium dihydrogen phosphate.
|
|
|
Bedlasky
International Hazard
Posts: 1244
Registered: 15-4-2019
Location: Period 5, group 6
Member Is Offline
Mood: Volatile
|
|
Vano: No, I don't mean NH4MnP2O7. I mean soluble complex [Mn(H2P2O7)3]3-. It's formed by oxidation of Mn2+ by permanganate in the presence of
pyrophosphate in acidic solution. Mn2+ can be also oxidized in the presence of orthophosphate, but you need high concentration of acid.
This reaction can be used for manganometric determination of manganese using potentiometric determination of equivalence point.
Quote: Originally posted by vano  | Tetrasodium pyrophosphate
Did you mean manganese ammonium pyrophosphate? This is a different reaction. Here manganese goes from 2 to 3. Copper pyrophosphate is made by the
exchange reaction. I made pyrophosphate from Mn oxide, phosphoric acid and ammonium dihydrogen phosphate. |
Manganese goes from 4 to 3 (if you use as starting point MnO2, you can also use Mn2O3 or MnO(OH)).
[Edited on 20-1-2021 by Bedlasky]
|
|
|
vano
National Hazard
Posts: 661
Registered: 22-3-2019
Location: Georgia
Member Is Offline
|
|
I do not know why I wrote 2. Can you tell me what color the solution was?
|
|
|
Bedlasky
International Hazard
Posts: 1244
Registered: 15-4-2019
Location: Period 5, group 6
Member Is Offline
Mood: Volatile
|
|
Red.
|
|
|
rockyit98
Hazard to Others
Posts: 283
Registered: 12-4-2019
Location: The Known Universe
Member Is Offline
Mood: no mood is a good mood
|
|
Disodium pyrophosphate can buy as food additive as buffering agent and as ingredient in leavening agents. Solubility in water 11.9 g/100 mL @ (20
°C) some what more than Tetrasodium pyrophosphate.try that.
"A mind is a terrible thing to lose"-Meisner
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
