Rocinante
Hazard to Others
Posts: 121
Registered: 13-11-2017
Member Is Offline
Mood: No Mood
|
|
Sound of low/medium/high VoD explosives
Do you experience notable difference in the sound of low VoD explosives (flash powder), medium VoD ones (3 - 4 km/s) and high VoD ones (6 km/s +)?
If so, what is the exact mechanism behind it? The first, fast expansion around the charge doesn't seem to be that different, i.e. a 100 g spherical
charge will detonate in a few microseconds in each case and blast sounds are in the 100 - 1000 Hz range, i.e. wave lenght of tens of cm.
|
|
|
wessonsmith
Hazard to Others
Posts: 203
Registered: 15-2-2018
Location: elsewhere
Member Is Offline
|
|
Quote: Originally posted by Rocinante  | Do you experience notable difference in the sound of low VoD explosives (flash powder), medium VoD ones (3 - 4 km/s) and high VoD ones (6 km/s +)?
If so, what is the exact mechanism behind it? The first, fast expansion around the charge doesn't seem to be that different, i.e. a 100 g spherical
charge will detonate in a few microseconds in each case and blast sounds are in the 100 - 1000 Hz range, i.e. wave lenght of tens of cm.
|
I can tell you the faster my VOD the more of a sharp and crisp bang I experience. I have seen it visually in my detonations in a large body of water.
The faster the VOD, the more opaque the white water shock wave is. Of course, I am using my iPhone in 1080p 240fps to actually see a snapshot of the
shockwave.
[Edited on 16-7-2019 by wessonsmith]
|
|
|
XeonTheMGPony
International Hazard
Posts: 1640
Registered: 5-1-2016
Member Is Offline
Mood: No Mood
|
|
the difference is caused by the shape of the pressure wave (Rise over time) which you can imagine changes with VOD
Low orders are more boomy, slower rate of rise on the leading edge of the pressure wave to peak amplitude.
Higher VOD is a sharper crack due to the short lead up to peak.
Distance will attenuate this to a degree but with a well tuned ear you can ruftimate the type. I'll dig through my library and see if I have any basic
PDFs on the subject for you
|
|
|
simply RED
Hazard to Others
Posts: 209
Registered: 18-8-2005
Location: noitacoL
Member Is Offline
Mood: booM
|
|
Due to the nature of the atmosphere - identical TNT equivalent detonating explosives will produce identical pressure vs time graphs. No matter the
VoD, even a thermobaric explosive will produce almost identical graph to its TNT eq. as TNT, if no enclosing is presented...
When logic and proportion have fallen sloppy dead...
|
|
|
Fantasma4500
International Hazard
Posts: 1681
Registered: 12-12-2012
Location: Dysrope (aka europe)
Member Is Offline
Mood: dangerously practical
|
|
the report may come across as more robust from something releasing higher intensity of energy at the same time
perchlorate flash the slower burning particle size aluminium produces a sharper bang, where higher quality would be a deeper bang
move onto magnalium and its very deep, onto magnesium and its a slight bit deeper yet again
another thing to take notice of is oxygen balance negative formulations or compounds causes a slight Fuel-Air-Explosive effect which makes the bang
very heavy
long back i managed to produce pitch black magnalium with coffee grinder and 150 mesh sieve (it was mostly +600 mesh of what came through)
this with simply potassium chlorate in a paper hemi was quite something, this basic composition in 50-50 by weight easily beat professional high
quality fireworks compositions such as cobra 6
a hint from a mate was to add KNO3 to KClO4-MgAl
so i did. it was a new level
previously he had me try KClO4-Al-S, also quite something, very heavy compared to KClO4-Al
so off i went, i mixed KNO3-MgAl-S 44:44:12 by weight and KClO4-MgAl 50:50 by weight
then i mixed equal proportions of this
10 grammes of this mix in a nice paper tube absolutely obliterated the loudness of 26.5g of what they stuff in cobra 6, i believe the MgAl was just
325 mesh even
however with higher energy density, the echo that comes back at you will be more intense, again to really figure out this you must be well aware of
oxygen balance in what you reference because that makes a major difference
i recall, one guy swapped the typical aluminium-binary mixture with magnalium, it wasnt OB negative even, but even at this point his 325 mesh MgAl
produced a deeper bang than his 000 black aluminium
something funny about magnesium, both metals have basically same melting point, and if its both same oxygen balance, then i really dont have a clue
why it would produce a deeper bang
|
|
|
MineMan
International Hazard
Posts: 1004
Registered: 29-3-2015
Member Is Offline
Mood: No Mood
|
|
Magnesium’s boiling point is very low. Hence the ultimate FAE
|
|
|
Pyro_cat
Hazard to Others
Posts: 243
Registered: 30-4-2018
Member Is Offline
Mood: No Mood
|
|
I have to think back 30 years but a medium sized trash bag of oxy acetylene barely out performed in terms of "loudness" an old school pineapple that I
assume was flash powder. Did them back to back. The oxy acetylene was definitely sharper in the way it shook things and was slightly different every
time depending on the oxygen balance. From more of a boom to sharp crack, you can adjust it.
I did not learn that from the internet or anyone, there was no internet, I just assumed I should get a result cause of the way the torch popped and
paying attention in chemistry class. That first small bag, pow, you must be kidding me THAT just happened ?!!! Be careful with this.
|
|
|
kratomiter
Hazard to Others
Posts: 106
Registered: 30-9-2012
Member Is Offline
Mood: No Mood
|
|
IIRC, if the shock wave is longer, the brain processes it as louder than a more prowerful but shorter shock wave.
|
|
|
Katie
Harmless
Posts: 35
Registered: 12-11-2019
Member Is Offline
|
|
Sound is nothing more than one’s body’s interpretation of a pressure wave, so there are more variables than just VOD. Distance from source,
humidity, surroundings, orientation of your ears, level of wax in your ears, amount of explosive material, and conscious attention will all affect how
you perceive the sound.
Personally, the closer I am, the sharper the sound. For example, holding a flame to a speck of lead azide on a butter knife has a loud sharp report,
but if I’m setting off Ammonal or PLX from 100 yards away, I can’t tell the difference unless I’m using very different amounts. I have a
virtually unlimited supply of PLX, lead azide, ANFO, ANNM, and Ammonal so next time I’m testing things out I’ll pay more attention to the sound
and try some different conditions.
|
|
|
Sulaiman
International Hazard
Posts: 3692
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Online
|
|
I have little experience with 'energetics' but lightning sounds very different at different distances, so I'd expect similar for explosives
CAUTION : Hobby Chemist, not Professional or even Amateur
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
