Mildronate
Hazard to Others
Posts: 428
Registered: 12-9-2009
Member Is Offline
Mood: Ruido sintetico
|
|
chemical waste books
Anybody knows books about chemical waste neutralization?
|
|
|
12thealchemist
Hazard to Others
Posts: 181
Registered: 1-1-2014
Location: The Isle of Albion
Member Is Offline
Mood: Rare and Earthy
|
|
I have the offerings of popular YouTube channels?
Attachment: Waste processing - 11.05.2018.pdf (87kB)
This file has been downloaded 625 times
|
|
|
Mildronate
Hazard to Others
Posts: 428
Registered: 12-9-2009
Member Is Offline
Mood: Ruido sintetico
|
|
I need book about waste treatment industrial various lab chemicals not only some metals, maybe some handbook or something.
|
|
|
BromicAcid
International Hazard
Posts: 3244
Registered: 13-7-2003
Location: Wisconsin
Member Is Offline
Mood: Rock n' Roll
|
|
In industry waste treatment is usually handled by and outside facility within the US. That's because you need certain certifications to treat
something which you earmark it as a waste.
|
|
|
morganbw
National Hazard
Posts: 561
Registered: 23-11-2014
Member Is Offline
Mood: No Mood
|
|
Many plants from before their inception have the waste in mind.
I can give examples from a few plants from the USA and Japan as well as Malaysia.
All three plants were designed with waste disposal, if not in mind, as a necessity.
Each plant had a tank farm to which the waste was pumped to, mostly what happened there was acid/base neutralization as well as solids removal if that
was above the limit set by the wastewater utility.
This was done by a variety of means, flocculation tanks, neutralization tanks, clarifiers, filter presses to take the excess solid.
In none of these plants was anything special done with lab waste, there was just not that much of it.
I could write a bit more on the waste as the plant I worked at began recycling most of the wastewater that it created and reused. It was pretty
elaborate and pushed by a chemical engineer that I did not like. I do have to give him nods here though.
My point is that industrial waste is not black and white. Industry waste disposal is not black and white. It is plant specific.
Special, small amounts, not taken into account with the plant design and disposal systems is farmed out.
|
|
|
j_sum1
Administrator
Posts: 6320
Registered: 4-10-2014
Location: At home
Member Is Offline
Mood: Most of the ducks are in a row
|
|
For my own lab, I recycle much of the waste I produce.
Ag gets recovered
Cr gets converter to Cr(III) and stored ready for making some dichromate in the future.
Iodide gets crystallised for I2 recovery
Cu gets precipitated as carbonate and reprocessed where volumes are larger
I process some waste by precipitating into innocuous forms
Pb gets converted to carbonate (really small volumes)
Cu in small volumes is also precipitated as carbonate
Mn usually ends up as MnO2 which I do not always recover
Other inorganics in small quantities also get converted to insoluble forms and stored.
When a sufficient quantity of these has accumulated I mix them with cement, sand and gravel to make a bucket of concrete. I try to proportion this
block so that it is relatively hard even if it is not construction quality. This block gets disposed of as solid waste destinbed for landfill.
Other waste streams
DCM is distilled and reused where possible. Otherwise it is allowed to evaporate.
Organic solvent waste is incinerated if I can do so cleanly.
acids and bases are neutralised and flushed with a reasonable quantity of water.
oxidants (usually pool chemicals) are reduced and also flushed with water
ethanol and non-hazardous solutions or suspensions are flushed with water -- usually test-tube scale quantities
The point is that I think about waste disposal in relation to what I am doing. I am not generally using anything that presents much of a hazard --
comparable to standard household use. But if I do something new I spend some time thinking about what I will do with the waste stream. For example I
have some As samples that I would love to clean up but will do some research into responsible treatment of residues before I attempt anything.
So the answer depends entirely on what your waste is and how much there is. There do exist easy solutions for many things.
|
|
|
FloridaAlchemist
Hazard to Self
Posts: 76
Registered: 8-6-2003
Location: USA
Member Is Offline
Mood: No Mood
|
|
Hazardous Chemicals and Disposal Guide
Hazardous Chemicals and Disposal Guide
M.A. Armour,L.M Browne,G.L. Weir
3rd Edition,1987
|
|
|
woelen
|
Thread Moved
23-5-2019 at 11:41 |
![[*]](images/xpblue/default_icon.gif){kind=icon}
