underground
National Hazard
Posts: 704
Registered: 10-10-2013
Location: Europe
Member Is Offline
|
|
Recycling H2SO4
I was wondering if it is possible to recycle and use again any leftover h2so4 after a nitration. If AN would be used as a nitrated salt, while you
concentrating it, ammonium nitrate/sulphate will decompose together with any leftover nitric acid remaining only h2so4 right?
[Edited on 5-8-2018 by underground]
|
|
OneEyedPyro
Hazard to Others
Posts: 280
Registered: 7-10-2015
Member Is Offline
Mood: No Mood
|
|
I thinkthe sulfate could really only be removed by distillation.
|
|
happyfooddance
National Hazard
Posts: 530
Registered: 9-11-2017
Location: Los Angeles, Ca.
Member Is Offline
Mood: No Mood
|
|
Mmmm, I am not 100% certain but I think if ammonium is the cation the sulfate should decompose at boiling temps.
|
|
OneEyedPyro
Hazard to Others
Posts: 280
Registered: 7-10-2015
Member Is Offline
Mood: No Mood
|
|
You're probably right. Ammonium sulfate should basically decompose into ammonia and sulfur dioxide at those temps, but I'm not sure though either.
|
|
Microtek
National Hazard
Posts: 872
Registered: 23-9-2002
Member Is Offline
Mood: No Mood
|
|
I would distil at reduced pressure, and then possibly fortify by running it through an SO3 absorber (mostly because I've recently made one; simply
distilling it would be fine for most purposes).
|
|
underground
National Hazard
Posts: 704
Registered: 10-10-2013
Location: Europe
Member Is Offline
|
|
I dont have the equipment to vacume distil it, i just want to keep everything simple. Ammonium sulphate decomp temp is close to the boiling point of
h2so4. I believe even if you are going to use concentrated h2so4 with added AS for any nitration, the additional AS wont contribute to any reduction
of the final yields.
[Edited on 16-8-2018 by underground]
|
|
Microtek
National Hazard
Posts: 872
Registered: 23-9-2002
Member Is Offline
Mood: No Mood
|
|
So what is it that you propose to do? Simply boil down the mixture of SA, NA, NH4HSO4, (NH4)2SO4 and AN (and remains of whatever has been nitrated)
that is left over from some nitration reaction? Do you have a glass distillation apparatus (even if it is not practical to pull a vacuum on it)? The
fumes that come off that operation will be extremely corrosive and toxic.
|
|
Sulaiman
International Hazard
Posts: 3722
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Offline
|
|
Details, notes or video available ?
|
|
underground
National Hazard
Posts: 704
Registered: 10-10-2013
Location: Europe
Member Is Offline
|
|
Quote: Originally posted by Microtek | So what is it that you propose to do? Simply boil down the mixture of SA, NA, NH4HSO4, (NH4)2SO4 and AN (and remains of whatever has been nitrated)
that is left over from some nitration reaction? Do you have a glass distillation apparatus (even if it is not practical to pull a vacuum on it)? The
fumes that come off that operation will be extremely corrosive and toxic. |
I dont have the apparatus but i am doing it outdoors and i am really away
|
|
Microtek
National Hazard
Posts: 872
Registered: 23-9-2002
Member Is Offline
Mood: No Mood
|
|
@ Sulaiman:
I posted a thread in Technochemistry about it:
Contact process
@ Underground:
I really think you should invest in some glassware (it costs next to nothing on ebay), at least a distillation setup. This would allow you to produce
pure fuming nitric acid, which works much better than nitrate + sulfuric acid.
But if that is out of the question, then go ahead and boil down your sulfuric acid waste. Just be aware of the drawbacks:
- The acid won't be pure, as some amount of salts will remain.
- You will lose some of the sulfuric acid to evaporation, even though you may operate below the boiling point.
- The fumes will be toxic corrosive, lacrymatory and very noticeable (by both sight and smell/choking sensation)
- If there are remains of the nitrated substance in the waste acids (and there usually will be), you may get flashing or even proper explosions as you
heat it.
|
|