ChemiChemism
Harmless
Posts: 1
Registered: 21-8-2017
Member Is Offline
Mood: No Mood
|
|
Old ether bottle - open under water?
Hello everyone,
I used to be a hobby chemist some years ago but have since long stopped. Unfortunately I have found an old bottle 6-7 years of BHT stabilised ether.
Its in a dark amber bottle and has been in a completely dark cabinet for 5 years. Prior to that it was opened a few times and at most 200mL was
removed.
I am a little worried as I simply cannot dispose of this professionally. This will costs me loads of money and might get me into legal trouble.
I figured the risk of opening the bottle is really low, but how low I cannot determine.
http://www.sciencemadness.org/talk/viewthread.php?tid=10380
garage chemist and Nicodem are making valid points. however, imagine the worst case scenario where some peroxides are present under the cap. would
opening the bottle under water (large bucket) prevent an inferno? Theres only 200-300 ml of air in the bottle (which is of low oxygen content due to
both the heavy ether vapour and its consumption in peroxide formation). my hypothesis is that a small explosion under cold water will not cause a full
blown fire. Or it will at least not create an explosion but a more controlled fire when the ether surfaces. Am I correct?
Other option would be to find a really sharp syringe with needle and inject ferrous sulfate solution via the top of the plastic thread. But then
again, would punctioring the bottle of the cap with a metal needle be dangerous?
If you have other suggestions, these are ofcourse welcome!
hope you can help! thank you!
|
|
|
Magpie
lab constructor
Posts: 5939
Registered: 1-11-2003
Location: USA
Member Is Offline
Mood: Chemistry: the subtle science.
|
|
Take the bottle to a remote field where you cannot be seen or heard. Step back 100 feet. Shoot the bottle with a shot gun.
The single most important condition for a successful synthesis is good mixing - Nicodem
|
|
|
woelen
Super Administrator
Posts: 8014
Registered: 20-8-2005
Location: Netherlands
Member Is Offline
Mood: interested
|
|
I would not worry too much about this. As I wrote in that old 2008 thread, ether is an OTC chemical in NL. It still is and can still be purchased in
drugstores. It is used for degreasing by the general public. Never ever did we have one exploding bottle of ether. If ether really had the risk of
exploding on opening the screwcap of the bottle, then it certainly would not be sold to the general public. The bottles in which it is sold are glass
bottles with a plastic cap and a very thin Al-foil liner in the cap. Available bottles are 100 ml and 1 l. Such bottles can be stowed away for years
by the general public and be forgotten, to be used again when something needs to be degreased again, which can be years later.
Just to make it less scary for you, put the bottle in a big tub (30 liters or so), full of cold water, such that the bottle can be completely
immersed. Open it, while it is standing upright. Some water may be sucked in if the water is cold, some air/vapor may bubble out if the water is warm.
Next, on a breezy day I would bring the bottle outside and slowly pour all the ether on a towel in order to let it evaporate. It is nearly non-toxic
and not a burden for the environment.
-------------------------------
An even better option is to find someone near you who does home chemistry and could be made happy with this bottle of ether!
[Edited on 22-8-17 by woelen]
|
|
|
unionised
International Hazard
Posts: 5126
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
Another answer is to build a bonfire somewhere remote, put the bottle in the middle of it, light the fire and go away.
|
|
|
zed
International Hazard
Posts: 2283
Registered: 6-9-2008
Location: Great State of Jefferson, City of Portland
Member Is Offline
Mood: Semi-repentant Sith Lord
|
|
Well, the Ether IS stabilized. Meaning, it is supposed to be OK in storage.
Still, it has been a while.
If you are nervous, don't do it by hand; use the method the fire department uses.
Magpie has already proposed it........Pick a nice wet day, take that bottle to a remote area...... And, put a bullet through it!
|
|
|
Dr.Bob
International Hazard
Posts: 2734
Registered: 26-1-2011
Location: USA - NC
Member Is Offline
Mood: No Mood
|
|
If you post roughly where you live someone may be willing to help you dispose of it. There are multiple ways to deal with it. Unless there are dry
white solids somewhere in or on the container, it is likely not a danger. If there are white solids near the top or on the cap, or on the bottom of
the liquid, that would be signs of danger. If the liquid is clear and no solids present, I would just pour it out somewhere away from anything and
let it evaporate, or use the bullet procedure.
|
|
|
ave369
Eastern European Lady of Mad Science
Posts: 596
Registered: 8-7-2015
Location: No Location
Member Is Offline
Mood: No Mood
|
|
Better rebottle the ether in a fresh bottle and sell it to someone. There are people for whom destroying useful reagents such as ether is tantamount
to blasphemy.
Smells like ammonia....
|
|
|
SWIM
National Hazard
Posts: 970
Registered: 3-9-2017
Member Is Offline
|
|
Seems to me that bottles of solvents are sealed not by the threads, but by a septum in the top of the cap, or by the top of the cap itself.
If the septum or cap top wasn't sealed right, you wouldn't have a bottle of ether after all this time, it would have evaporated.
So if the top of the bottle is still sealed, the peroxides, if there are any, should have formed inside, not on the threads.
Any ether that got on the threads when the cap was off would have evaporated quickly and had no chance to form peroxides.
Aren't these peroxides fairly soluble in the ether? If so how about leaving the bottle upside down for a while to dissolve any that might have
deposited under the cap?
Also, if I'm wrong and there could be ether on the threads, that would still be outside the septum and accessible to the environment around it, so you
could always place the bottle cap-down in a container of something appropriate to decompose any peroxides there safely. You mentioned ferrous sulfate.
But if you aren't going to salvage the ether I like the shotgun idea suggested earlier.
For non-shotgun-owning chemists you can always just throw rocks at it from a distance, or throw the bottle really hard at some hard surfaced target.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
