Db33
Hazard to Others
Posts: 206
Registered: 25-11-2016
Member Is Offline
Mood: No Mood
|
|
Where can i find good storage bottles?
I am looking for good storage bottles. For liquids and solids. Id like to get amber glass bottles, but im also looking for any other good cheap
options for storing various dry powder chemicals and various solvents and liquids. on eBay for some reason the only containers i can find for this are
too expensive, does anyone have a link or a suggestion where i can get good bottles for storing chems?
|
|
|
gdflp
Super Moderator
Posts: 1320
Registered: 14-2-2014
Location: NY, USA
Member Is Offline
Mood: Staring at code
|
|
I understand the feeling, putting your newly synthesized compound in a recycled plastic bottle doesn't quite give you the same satisfaction as a
proper container, does it? This thread might give you some places to look. I would get a few more than you think you need, it's always handy to have some laying around.
|
|
|
PeterC
Harmless
Posts: 23
Registered: 11-12-2016
Member Is Offline
Mood: No Mood
|
|
For small samples of non corrosive things you can use cheap vials off of aliexpress (https://www.aliexpress.com/item/12Pcs-1ml-2ml-3ml-5ml-10ml-M...) but for anything that will react with plastic or try to escape its container you
should use a media bottle with a teflon cap.
|
|
|
Dr.Bob
International Hazard
Posts: 2734
Registered: 26-1-2011
Location: USA - NC
Member Is Offline
Mood: No Mood
|
|
I have a variety of clear and amber bottles and vials available, they are not quite as cheap as plastic, but depending on what you want, I have lots
of smaller ones available for pretty low prices. The vials are as little as $1 per handful (a small ziplock bag full), or about $5-15 per case (cases
vary from 72 to 200, depending on the vial size). And I have clear and amber bottles, many with PTFE lined caps, for $1-3, depending on the size,
type, and quantity. I have shipped several people here an assortment of 50-60 bottles and a few vials for $50-60 in a medium sized flat rate box,
which is about $13 postage. Most of these are brand new, only a handful of sizes do I have any used, which I sell for less. If you want to see what
I have, I can send a sample pack as well, for a small amount.
|
|
|
Sulaiman
International Hazard
Posts: 3696
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Offline
|
|
or, if like me you want to economise,
remember that far more money/research/development/testing goes into food containers than reagent containers,
to collect enough bottles/jars/containers to make matching sets of reagent containers,
you may have to switch brands for a while ......... suffer for your art
P.S. welcome to the world of the damned ...
amateur chemists, doomed to roam the aisles, perpetually seeking 'useful stuff' 
[Edited on 24-12-2016 by Sulaiman]
CAUTION : Hobby Chemist, not Professional or even Amateur
|
|
|
Corrosive Joeseph
National Hazard
Posts: 915
Registered: 17-5-2015
Location: The Other Place
Member Is Offline
Mood: Cyclic
|
|
Quote: Originally posted by Sulaiman  | P.S. welcome to the world of the damned ...
amateur chemists, doomed to roam the aisles, perpetually seeking 'useful stuff'
[Edited on 24-12-2016 by Sulaiman] |
This is so funny coz it's true...............
And I am definately guilty of switching brands just for the containers they come in. Have been collecting these for a long time now but I now possess
quite a stack of crates of beautiful 330ml amber glass bottles, 500ml clear glass bottles (originally containing fruity soft drinks) and a ton of
square coffee jars. I love the fact my containers are all uniform, made of glass and FREE. It's quite pleasing actually.
My therapist says I am working my way through it...................
/CJ
(That last statement is actually sarcasm and NOT true) 
Being well adjusted to a sick society is no measure of one's mental health
|
|
|
Db33
Hazard to Others
Posts: 206
Registered: 25-11-2016
Member Is Offline
Mood: No Mood
|
|
does anyone have any opinion on all of the glass vases and stuff they sell at Michaels/Joanns fabrics as vases? They are clear/amber/green glass
mostly with corks. I was thinking of using some of these.
Also does anyone have any idea on printable labels? Is there a program or something i can buy that i can use to print out or buy labels to make my own
chem labels?
|
|
|
PeterC
Harmless
Posts: 23
Registered: 11-12-2016
Member Is Offline
Mood: No Mood
|
|
You can use Avery print out labels (they won't stand up to much), but I prefer to make a Quartzy for my lab and just use a small label-maker to put a
name/serial number on each bottle.
|
|
|
PirateDocBrown
National Hazard
Posts: 570
Registered: 27-11-2016
Location: Minnesota
Member Is Offline
Mood: No Mood
|
|
For ordinary dry chemicals, that aren't corrosive, oxidizers, or volatile, it's hard to go wrong with ordinary Mason jars. They are cheap, come in
many useful sizes, universally available, have standard size closures, (which are themselves easily replaceable) and are completely airtight.
|
|
|
JJay
International Hazard
Posts: 3440
Registered: 15-10-2015
Member Is Offline
|
|
This is actually a very serious problem, I've found. Good reagent bottles usually cost more than good flasks.
I do have several ground glass reagent bottles, but most of them are still sitting in their packages. They have to be sealed with joint grease to be
airtight, and I worry about them getting knocked over or broken. Also, I am not confident that they will do a good job of handling substances with a
high vapor pressure, though they seem to be appropriate for acids or very short-term storage.
I have found that soda bottles make extremely poor containers; the plastic ones are slightly permeable and removing all of the food ingredients from
even the glass ones them seems to be impractical. Vinegar jugs are better.
There are many substances that you can store in repurposed solvent containers, empty hydrogen peroxide bottles, Mason jars, spice bottles, Ziplock
bags, etc. You can find HDPE lids for Mason jars if you shop around.
You'd think that the hardware store bottles that sulfuric acid comes in would be good storage containers, but many of them have foil-lined caps.
One of the best ways to store chemicals is in a Duran (or other brand) media bottle with PTFE caps, but the bottles aren't cheap, and PTFE caps are
extremely expensive. You can get PTFE-lined caps at far more reasonable cost.
You can also get PTFE-lined caps for Boston round bottles; Qorpak makes good caps that are really quite economical. An amber Boston round bottle with
a PTFE cap can be used to store many liquids. Qorpak makes a lot of good storage containers.
Boston round bottles and media bottles are sometimes available in shatterproof and/or amber versions.
Dr. Bob is a trustworthy source for containers.
[Edited on 27-12-2016 by JJay]
|
|
|
Estal
Harmless
Posts: 1
Registered: 28-12-2016
Member Is Offline
Mood: No Mood
|
|
You all should look on uline. It's where I get all my containers as they're always cheap. They even have amber jars/bottles ranging from $1 for the
small up to $2 for large ones.
https://www.uline.com/BL_755/Amber-Wide-Mouth-Glass-Jars?key...
|
|
|
JJay
International Hazard
Posts: 3440
Registered: 15-10-2015
Member Is Offline
|
|
Uline carries Boston round bottles... they don't seem to carry PTFE caps, but they do have a wide range of containers.
|
|
|
Herr Haber
International Hazard
Posts: 1236
Registered: 29-1-2016
Member Is Offline
Mood: No Mood
|
|
Arent Boston / Winchester bottles GL 45 threaded ?
If so, finding PTFE / PTFE lined caps should be easy.
|
|
|
Morgan
International Hazard
Posts: 1694
Registered: 28-12-2010
Member Is Offline
Mood: No Mood
|
|
I've bought Teflon sheets before which aren't too expensive and wondered if you could just cut some neat disk shapes out and make your own. It's
fairly soft and would probably take an impression of the rim of the bottle if tightly screwed on.
|
|
|
JJay
International Hazard
Posts: 3440
Registered: 15-10-2015
Member Is Offline
|
|
Boston round bottles aren't GL 45 threaded, but the caps are easy to find and much cheaper than GL 45 caps.
|
|
|
Db33
Hazard to Others
Posts: 206
Registered: 25-11-2016
Member Is Offline
Mood: No Mood
|
|
is there a program i can download so that i can print out my own labels for the bottles? Im no sure if they make printing paper that you have sticky
backs that you can make them into labels but if anyone has any ideas id like to know.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
