Noflers
Harmless
Posts: 9
Registered: 14-2-2016
Member Is Offline
Mood: No Mood
|
|
Broke the Inlet Connector of Graham Condenser, Help Please.
I snapped the inlet connector on my condenser, what should I do to remedy the situation? I'm thinking I'd rather glue the hose directly to the stub
where it broke than to glue the broken glass together. as it would just be a weak spot.
I had the idea of a sort of tape that can be heat cured, is there such a thing?
What type of glue should I look for?
Thanks for the help!
[Edited on 3/1/2016 by Noflers]
|
|
Dr.Bob
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2690
Registered: 26-1-2011
Location: USA - NC
Member Is Offline
Mood: No Mood
|
|
It will be very hard to glue the barb back to the water inlet and have it hold, you are right there. If the hose is at the top, there will be less
pressure on it there, as that is normally the outlet, and thus lower pressure. If you can get the hose over the stub of the hose barb, you may be
able to hold it in place with some glue, tape, wire, whatever, especially if it is the outlet. But it will be iffy at best. Since the water jacket
should not get too hot, the temperature stability is not critical. You can also use cold air with it and still get a lot of usage, blow air through a
tube in cold water and then into the condenser. I have used air many times, best for higher bp solvents.
The best solution is a glass blower, as that type of repair is pretty easy, just putting a new hose barb on. If you can find one nearby, that would
be a simple repair. I had a few condensers fixed that way a while back.
|
|
hissingnoise
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 3940
Registered: 26-12-2002
Member Is Offline
Mood: Pulverulescent!
|
|
Sometimes it's possible to insert a tight-fitting hose in the hole if enough of the neck remains . . .
|
|