Sciencemadness Discussion Board
Not logged in [Login ]
Go To Bottom

Printable Version  
Author: Subject: Brown ring test for Nitrate/Nitric acid in high SG liquids.
feacetech
Hazard to Others
***




Posts: 163
Registered: 12-2-2007
Member Is Offline

Mood: No Mood

[*] posted on 29-3-2015 at 12:47
Brown ring test for Nitrate/Nitric acid in high SG liquids.


Will this test work with Liquid Aluminium Aulphate (Alum)?

Some background below.

I ask this as I suspect Nitric acid contamination in some Alum I have.

pH should be 2.4, however it is 0.83.

The SG is 1.324

The Sulphuric acid used to make the Alum fails the reducing test so it is not ultra pure.

Iron in the suspect Alum is 24.1 ppm.
Al2O3 is on the low side 7.89 ppm.

I suspect the Nitric acid may have come from the tanker carting the Alum. However I need to prove this either way.

There may not be a great deal of Nitric in the sample so dilution of the alum may not work.

Concerns: 1. the SG of the Alum is too high, 2. the sulphuric content of the alum may interfere with the test. 3. The impurities in the acid may interfere.

3. can be alleviated with a control sample of Alum

Thank you.

[Edited on 29-3-2015 by feacetech]
View user's profile View All Posts By User
feacetech
Hazard to Others
***




Posts: 163
Registered: 12-2-2007
Member Is Offline

Mood: No Mood

[*] posted on 29-3-2015 at 17:06


I'm guessing it will be fine, I will try this test once I get some iron sulphate

unless anyone has a better test
View user's profile View All Posts By User
Oscilllator
National Hazard
****




Posts: 659
Registered: 8-10-2012
Location: The aqueous layer
Member Is Offline

Mood: No Mood

[*] posted on 30-3-2015 at 02:34


If that doesn't work, you can always try boiling a concentrated solution of your alum along with some copper turnings.
View user's profile View All Posts By User
feacetech
Hazard to Others
***




Posts: 163
Registered: 12-2-2007
Member Is Offline

Mood: No Mood

[*] posted on 1-4-2015 at 15:10


Worked fine with a positive control, after a while an alum ppt will form at the liquid interface.

One of the positive controls had a very strong reaction and some sort of pink/red compound started to leach into the heavier H2SO4 phase, it looked like KMnO4 (but we no it wasn't).

My iron sulphate was mono hydrate and fert grade.

long story short qualitatively there was no detectable nitric acid in my low pH alum. +ve and -ve controls worked

[Edited on 1-4-2015 by feacetech]
View user's profile View All Posts By User

  Go To Top