ecos
Hazard to Others
Posts: 464
Registered: 6-3-2014
Member Is Offline
Mood: Learning !
|
|
usage of acetone for blasting gelatin
Hi ,
while preparing blasting gelatin i found two ways :
1- pour NG over NC and keep stirring
2-dissolve NC into hot acetone then add NG after it cool down
I don't understand the benefit of acetone, is it used as a solvent then it will volatile ?
I made a lot of searches but couldn't find an answer for my question
[Edited on 19-3-2014 by ecos]
|
|
Bert
Super Administrator
Posts: 2821
Registered: 12-3-2004
Member Is Offline
Mood: " I think we are all going to die. I think that love is an illusion. We are flawed, my darling".
|
|
Ecos, I suggest you restrict yourself to asking questions in the "short question quick answer" thread. The day you ask a question worth starting a new
thread over, a moderator will notice and bust one out for you. If you keep starting a new thread for EVERY question, the moderators will notice that
too- And may remove your posting privileges.
--------------
Acetone is an efficient solvent for nitrocellulose, even the more highly nitrated grades. It's a processing aid to speed up production, then is
evaporated out of the mixture.
Nitroglycerin also will dissolve nitrocellulose of course, but rather slowly compared to acetone. Warming a large ammount of nitroglycerin in a
factory setting to speed the dissolving/gelling process is a bit dicierthan
warming up some acetone and nitrocellulose...
The acetone doesn't really need to be heated to dissolve the nitrocellulose, it just speeds the process up a bit.
Rapopart’s Rules for critical commentary:
1. Attempt to re-express your target’s position so clearly, vividly and fairly that your target says: “Thanks, I wish I’d thought of putting it
that way.”
2. List any points of agreement (especially if they are not matters of general or widespread agreement).
3. Mention anything you have learned from your target.
4. Only then are you permitted to say so much as a word of rebuttal or criticism.
Anatol Rapoport was a Russian-born American mathematical psychologist (1911-2007).
|
|
ecos
Hazard to Others
Posts: 464
Registered: 6-3-2014
Member Is Offline
Mood: Learning !
|
|
Thanks Bert, I will take care next time to post in the "short question quick answer" thread, I was not aware of this.
just to finalize the point , so what is the quantity needed for acetone to dissolve 10grams of NC ?
I started to see that it doesn't 100% dissolve all in acetone ! so i should keep adding acetone till all NC disappear ?
|
|
NeonPulse
Hazard to Others
Posts: 417
Registered: 29-6-2013
Location: The other end of the internet.
Member Is Offline
Mood: Isolated from Reality! For Real this time....
|
|
you can use excess acetone to dissolve your NC and just let it evaporate until it is the desired consistency, but you do need to shift the outer layer
that formed as to expose a fresh area as to open it up to evaporate.
Simply adding the nc to your ng is probably easier but takes longer. Methyl nitrate is a far better solvent for nc in my opinion but is far more
volatile than acetone and the methyl nitrate blasting jelly needs to be used very quickly though as it fast becomes useless via evaporating MN if not
made airtight.
The methyl nitrate will also attack some plastics so its best to test if its compatible before use. egdn is also a pretty good dissolver of nc too.
but you MUST have your nitrocellulose neutral for safety reasons. go that extra mile to ensure this.
|
|
Bert
Super Administrator
Posts: 2821
Registered: 12-3-2004
Member Is Offline
Mood: " I think we are all going to die. I think that love is an illusion. We are flawed, my darling".
|
|
What is the source of the nitrocellulose.
Home made? If so, how did you make it- And purify it?
Rapopart’s Rules for critical commentary:
1. Attempt to re-express your target’s position so clearly, vividly and fairly that your target says: “Thanks, I wish I’d thought of putting it
that way.”
2. List any points of agreement (especially if they are not matters of general or widespread agreement).
3. Mention anything you have learned from your target.
4. Only then are you permitted to say so much as a word of rebuttal or criticism.
Anatol Rapoport was a Russian-born American mathematical psychologist (1911-2007).
|
|
ecos
Hazard to Others
Posts: 464
Registered: 6-3-2014
Member Is Offline
Mood: Learning !
|
|
yes , it is homemade
i followed theses steps : https://www.youtube.com/watch?v=QQ5q9G1lHUc
but in the last step i boiled the NC in water then dry it
[Edited on 21-3-2014 by ecos]
|
|
Bert
Super Administrator
Posts: 2821
Registered: 12-3-2004
Member Is Offline
Mood: " I think we are all going to die. I think that love is an illusion. We are flawed, my darling".
|
|
You didn't use a base to neutralize acid residue in the cotton? Just boiled it in water and dried it?
Please tell me you do not have this stored inside your parents home or anywhere a fire or explosion could injure innocent bystanders?
Rapopart’s Rules for critical commentary:
1. Attempt to re-express your target’s position so clearly, vividly and fairly that your target says: “Thanks, I wish I’d thought of putting it
that way.”
2. List any points of agreement (especially if they are not matters of general or widespread agreement).
3. Mention anything you have learned from your target.
4. Only then are you permitted to say so much as a word of rebuttal or criticism.
Anatol Rapoport was a Russian-born American mathematical psychologist (1911-2007).
|
|
ecos
Hazard to Others
Posts: 464
Registered: 6-3-2014
Member Is Offline
Mood: Learning !
|
|
man !
ofcourse i did neutralization !!! , after that i boiled it to get out the extra remaining acids
plus i do that in my roof , I have a separate room for this !
[Edited on 22-3-2014 by ecos]
|
|
Bert
Super Administrator
Posts: 2821
Registered: 12-3-2004
Member Is Offline
Mood: " I think we are all going to die. I think that love is an illusion. We are flawed, my darling".
|
|
Hope it's a big room with a fume hood-
Please take your lab sample of nitro and NC to a safe place now. Spread them thinly on a large sheet of cardboard, light a down wind edge and burn
them. Take your phone or a friend's phone and video the burn- Post it to youtube and PM me the link. You may make more later, perhaps. But not until
you have learned some theory, a student lab is pointless without theory- And notes.
Go look at the sections on nitrocellulose and smokeless powder manufacture in Tenney Davis' Chemistry of Powder and Explosives- see what is done
commercially to stabilize nitrocellulose.
Ask some more questions after you have found answers to the below:
Look for the solubility information for different solvents and NC of different degrees of nitration. Think about why your NC behaved as it did on
trying to dissolve it?
Then look for a chemical BESIDES the bases- carbonates, ammonia, etc. that could be put into the later (2nd) boiling water bath to help desorb acid
residue from the fibers and ensure a longer stability. Come back with a name.
Then ask some more questions based on these readings. Write the questions carefully, well enough so someone who doesn't know much of what you do will
understand, without assuming anything. Go over what you write, think of how to say the most with the fewest words. Spell check it when finished.
This is your homework for the week- If you don't do the homework, you will not get to go on to the next class.
Class dismissed!
[Edited on 22-3-2014 by Bert]
Rapopart’s Rules for critical commentary:
1. Attempt to re-express your target’s position so clearly, vividly and fairly that your target says: “Thanks, I wish I’d thought of putting it
that way.”
2. List any points of agreement (especially if they are not matters of general or widespread agreement).
3. Mention anything you have learned from your target.
4. Only then are you permitted to say so much as a word of rebuttal or criticism.
Anatol Rapoport was a Russian-born American mathematical psychologist (1911-2007).
|
|
Fantasma4500
International Hazard
Posts: 1681
Registered: 12-12-2012
Location: Dysrope (aka europe)
Member Is Offline
Mood: dangerously practical
|
|
if you decide to use the NC for mix-secondaries then you need to neutralize it more than just well or use it straight away, as many other secondaries
gets quite sensitive with acid present...
you could perhaps dissolve the NC in acetone and add some drops of NH4OH solution, then let it dry out and crush up the dried out plastic
if you use NC for main charge -- no problems
but mixing NC that has not been boiled for several hours in NaHCO3 solution is just a bad idea
|
|
Metacelsus
International Hazard
Posts: 2538
Registered: 26-12-2012
Location: Boston, MA
Member Is Offline
Mood: Double, double, toil and trouble
|
|
Quote: Originally posted by ecos |
of course i did neutralization !!! , after that i boiled it to get out the extra remaining acids
|
If any acid remained, you didn't neutralize it.
|
|
Bert
Super Administrator
Posts: 2821
Registered: 12-3-2004
Member Is Offline
Mood: " I think we are all going to die. I think that love is an illusion. We are flawed, my darling".
|
|
The technology to make good, long lasting NC was well known before WWII. I have WWII US 30-06 ammunition loaded with wartime single base powder that
is still just fine, only a little lower velocity than the new stuff- WW II surplus IMR powder is still being sold & used by reloaders around here,
very little has gone over the edge and degraded.
It's all in COPAE. Nothing out of reach if you can read the books, have chemicals to make NC, the ability to heat water and can piss, you can
stabilize this plenty well for a little storage.
http://www.sciencemadness.org/talk/viewthread.php?tid=2415
Rapopart’s Rules for critical commentary:
1. Attempt to re-express your target’s position so clearly, vividly and fairly that your target says: “Thanks, I wish I’d thought of putting it
that way.”
2. List any points of agreement (especially if they are not matters of general or widespread agreement).
3. Mention anything you have learned from your target.
4. Only then are you permitted to say so much as a word of rebuttal or criticism.
Anatol Rapoport was a Russian-born American mathematical psychologist (1911-2007).
|
|
ecos
Hazard to Others
Posts: 464
Registered: 6-3-2014
Member Is Offline
Mood: Learning !
|
|
Quote: Originally posted by Bert | Hope it's a big room with a fume hood-
Please take your lab sample of nitro and NC to a safe place now. Spread them thinly on a large sheet of cardboard, light a down wind edge and burn
them. Take your phone or a friend's phone and video the burn- Post it to youtube and PM me the link. You may make more later, perhaps. But not until
you have learned some theory, a student lab is pointless without theory- And notes.
Go look at the sections on nitrocellulose and smokeless powder manufacture in Tenney Davis' Chemistry of Powder and Explosives- see what is done
commercially to stabilize nitrocellulose.
Ask some more questions after you have found answers to the below:
Look for the solubility information for different solvents and NC of different degrees of nitration. Think about why your NC behaved as it did on
trying to dissolve it?
Then look for a chemical BESIDES the bases- carbonates, ammonia, etc. that could be put into the later (2nd) boiling water bath to help desorb acid
residue from the fibers and ensure a longer stability. Come back with a name.
Then ask some more questions based on these readings. Write the questions carefully, well enough so someone who doesn't know much of what you do will
understand, without assuming anything. Go over what you write, think of how to say the most with the fewest words. Spell check it when finished.
This is your homework for the week- If you don't do the homework, you will not get to go on to the next class.
Class dismissed!
[Edited on 22-3-2014 by Bert] |
I think my NC has much Nitrogen (more than 13% N) which made it insoluble!
i checked the "Preparation of Pyrocellulose", the most interesting thing , he didn't use sodium bicarbonate for neutralization , he only tried washing
and boiling.
thanks for the reference and the HW
|
|