CaptainOfSmug
Harmless
Posts: 36
Registered: 3-5-2012
Location: In the Nightside Eclipse
Member Is Offline
Mood: No Mood
|
|
Baby rash ointments etc..
Hello all!
Not sure exactly what thread this would fall under and admittedly, I haven't done very much research on this subject. Anyhow, I just found out me and
my wife are expecting a baby! Naturally, my chemistry hobby budget will be decreasing but I"m trying to get my wife on board to help me maintain my
passion a little bit more on something that could save a little extra cash by doing it yourself. Of course I'm not thinking about making any sort of
medication for my baby  but I was wondering about maybe some sort of baby
ointment/cream/salves/ that I could just make myself and thus allowing my lab to continue running. Anybody have any experience in this area or have
some knowledge they could shed some light on? It's appreciated thanks!
|
|
|
Fantasma4500
International Hazard
Posts: 1681
Registered: 12-12-2012
Location: Dysrope (aka europe)
Member Is Offline
Mood: dangerously practical
|
|
you could go check up on whats in this stuff, assuming its decently unharmful stuff there shouldnt be a too big risk on making it yourself.. say..
calcium carbonate..
generally i think youre gonna get a shitstorm for wanting to apply some homemade stuff to any person (:
|
|
|
Endimion17
International Hazard
Posts: 1468
Registered: 17-7-2011
Location: shores of a solar sea
Member Is Offline
Mood: speeding through time at the rate of 1 second per second
|
|
In order to apply anything to a human being and be legally certain that no unknown side effects can appear, you'll need pharma grade reagents. Those
don't need to be pure, but they're are certified to lack things like dangerous heavy metals, carcinogenic organic matter, etc.
They're sometimes very expensive, especially if bought in small quantities.
Most bases for oinments and creams are made with zinc oxide and petroleum jelly (such mixture is good for the diaper rash), and powders are made of
talcum, which is mica and therefore soft and less reactive, not calcium carbonate which is hard and more reactive.
What you want to avoid is boric acid. It was used quite a lot in the past for irritated skin. It helps, but the rate of elimination from the organism
is very slow, so if the baby is exposed to it on a regular basis, toxicity is apparent.
|
|
|
ElectroWin
Hazard to Others
Posts: 224
Registered: 5-3-2011
Member Is Offline
Mood: No Mood
|
|
commercial "baby oil" is odourless mineral spirits (pharma grade), with some perfume in it.
these are alkanes, ie: saturated acyclic hydrocarbons having carbon numbers from around 15 through 40. they are biologically inert.
https://en.wikipedia.org/wiki/Mineral_oil
https://en.wikipedia.org/wiki/Petroleum_jelly
making this yourself would entail removing cyclic and unsaturated fractions from petroleum, which will be challenging.
i would advise substituting a hypoallergenic vegetable oil.
|
|
|
Endimion17
International Hazard
Posts: 1468
Registered: 17-7-2011
Location: shores of a solar sea
Member Is Offline
Mood: speeding through time at the rate of 1 second per second
|
|
Using petroleum to make anything one would smear over his baby's body is not challenging. It's impossible. That's why we have petroleum refineries
which export raw material for later processing to different chemical plants, and they make more refined materials that are then used by another plants
that make the stuff you can put on babies. 
|
|
|
Dr.Bob
International Hazard
Posts: 2755
Registered: 26-1-2011
Location: USA - NC
Member Is Offline
Mood: Mildly disgruntled scientist
|
|
Just buy the generic stuff at any store, it will be cheaper than you can make it, most likely. I learned years ago that many products cost more to
make than they are to buy. For anything where there is not an expensive active ingredient, it will not save much. You would be better to make
some diapers at home, they are much more expensive. It is like trying to make shampoo, when it costs $1 for a bottle.
Now if you are trying to make something that has a small amount of an expensive ingredient, then that makes sense. Like Viagra, minoxidil, or other
compounds that are highly diluted in the final product, that is where you could save money, although even that is not trivial by any means. Pet meds
and pesticides are another area where you can save a lot with some work. And most pests don't complain that you used an generic pesticide...
|
|
|
phlogiston
International Hazard
Posts: 1379
Registered: 26-4-2008
Location: Neon Thorium Erbium Lanthanum Neodymium Sulphur
Member Is Offline
Mood: pyrophoric
|
|
Congrats! As a proud father of four, my oldest daughter now being 6, my advice would be to wait it out a little. Soon, your offspring will get very
curious about everything and there are many many fun experiments you can do together that will get them thinking. You're wife will proudly tell
everyone you have your own lab and do experiments with the kid(s).
In the first year or so you probably will have little time to spend anyway on anything other than your job, household and care for your child.
Enjoy it!
-----
"If a rocket goes up, who cares where it comes down, that's not my concern said Wernher von Braun" - Tom Lehrer |
|
|
woelen
Super Administrator
Posts: 8027
Registered: 20-8-2005
Location: Netherlands
Member Is Offline
Mood: interested
|
|
I only can confirm what phlogiston said. I have even given birthday parties where the kids were allowed to do experiments themselves. This was when
they were 10 years old or so. The experiments I allowed them to do were:
- Making volcano of NaHCO3 and vinegar, with food dye-stuff added for effects.
- Changing colors with red cabbage and adding vinegar, dilute ammonia, dilute NaHCO3. I did experiments with NaOH and 10% HCl as demo.
- Writing with invisible ink (dilute solution of K4Fe(CN)6), which after drying was made visible by spraying a dilute solution of FeCl3 in 0.5% acetic
acid.
I did some demos as well (kids just watching from a few meters distance, I handled the materials):
- dissolving copper coin in conc. HNO3
- lighting a mix of Ba(NO3)2 with some fuel, using a magnifying glass and sunlight. This gives a greenish flame.
The kids loved it, and the parents of the kids also found it a very good idea. No chemophobia at all, they regarded it as great fun!
|
|
|
Hockeydemon
Hazard to Others
Posts: 218
Registered: 25-2-2013
Member Is Offline
Mood: No Mood
|
|
Rather than trying to make the things that you would buy at the store why not look up older remedies that hippy (all natural) people use? Figure out
what chemical it is that is making the old remedy work, and try to extract it from that source? Then you shouldn't have to worry about much in regards
to safety?
|
|
|
violet sin
International Hazard
Posts: 1482
Registered: 2-9-2012
Location: Daydreaming of uraninite...
Member Is Offline
Mood: Good
|
|
I too am in the process of taking down my lab for the same reason and have been searching for excuses to use benign chems for my amusement. Gardens
need chems too. Our squash, tomatoes etc. were suffering from blossom rot, Lost fruit and poor health. Solution was soluble calcium and magnesium.
It wasn't to terribly fun/exciting but beakers, mixing, filtration and crystals were involved. Agg lime + vinegar for a soluble non-chlorine Ca
source. Just Epsom salt for the mag  no nitric acid on hand also . Any how the plants greened by the end of that day and by day two the soft spots on
our tomatoes hardened and began taking color( ripening).
Then I did the potassium carbonate from banana's ash. Even got to do a recrystillization on that one not going to use it for fertilizer though, it was just safe chems. Our child's not due till end of december so I'm
trying to do as much as possible for now. I don't think I will even lose any sleep over no chem, with all the wonders of my first child. Besides
deff won't have time to pour through books n patents to find the fun stuff any way.
More than likely I'll switch to electronics r metal working project that can be put down at any given moment. Congrats and best of luck with your
continued experimentation
-violet sin-
|
|
|
phlogiston
International Hazard
Posts: 1379
Registered: 26-4-2008
Location: Neon Thorium Erbium Lanthanum Neodymium Sulphur
Member Is Offline
Mood: pyrophoric
|
|
Metal working: Nah, you'll worry about the noise of the lathe/saw/hammer/whatever after you have FINALLY managed to get your little girl/boy to sleep.
Electronics: Some of the lead in the solder inevitably gets on your fingers. I suspended my electronics projects for that reason, especially when I
found the kids would FINALLY fall asleep when I allowed them to suck on the tip of my little finger (works the first month or two).
You'll see. You will value every minute of sleep you can get the first few weeks.
-----
"If a rocket goes up, who cares where it comes down, that's not my concern said Wernher von Braun" - Tom Lehrer |
|
|
violet sin
International Hazard
Posts: 1482
Registered: 2-9-2012
Location: Daydreaming of uraninite...
Member Is Offline
Mood: Good
|
|
phlogiston: I am sure I will appreciate all my sleep as well. so far only work in copper and silver with hammer/punches so no big tools to worry
about. projects are mostly in the basement for the noise( and privacy). my fiance can't seem to hear me at all hammering away from down there,
which is good. also in electronics I am really not that skilled(armature status and learning), but that doesn't diminish the satisfaction of a job
well done. basically meaning I am not often soldering overly complicated things or handling lead too much. I know even with 95%+ Sn solder a little
Pb is too much, gloves maybe?. I will deff keep your words in mind, as safety is priority 1
a guy's gotta be able to create on some level right. whatever the case I am confident I will find a match. more watercolor painting, just
SOMETHING to quiet a busy imagination. enough about all that an back to chem...
captainofsmug: got a few more ideas,
1) you can copper plate some lill booties when that time comes. electrochem isn't every ones fave but counts in my book.
2) try somenting novel like grow a crystal of ???? until you kid is born an save it for him her.
3) make a couple fireworks to celebrate the new arrival. more color and less pop type or just not with the newborn present for loud ones.
4) get into soil/water testing if you drink from a well or grow veggies,
5) manufacture something of value to help w/ bills(legal of course),
6) extract essence oils for odor control,
7) read read read on the chems already in your household products, shampoo's and all. get well versed what chems to avoid such as fillers or poor
main ingredients that company's are pumping out to save $.
on suggestion #5, I came up with an organic and safe mold/mildew treatment for coastal tomato plants n vegies. it has been passed out to a few
people, all with great success. basically waiting to slap a label on some bottles and start selling local small scale.
I don't know what areas of chem interest you so my suggestions are kinda all over the place. hope one of em works for ya.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
