Practicaler
Harmless
Posts: 42
Registered: 24-3-2012
Member Is Offline
Mood: Exploding
|
|
rocket fuel for supersonic rocket motors and can take lots of weight with it
There are lots of rocket fuel most common is potassium nitrate and sucrose. And ammonium nitrate composite propellants . Basically what i wan to ask
is that
1_ a rocket fuel which can make rocket motors to fly at speed at least 100m/s
2_a rocket fuel which has such a huge power that 1 kg of rocket fuel can take at least 3 kg of mass with it at speed at least 100 m/s
3_ what are your views regarding potassium nitrate an sucrose can it do such a work .
|
|
|
KonkreteRocketry
Hazard to Others
Posts: 165
Registered: 12-11-2012
Location: Dubai
Member Is Offline
Mood: No Mood
|
|
As long as the burning surface area is large enough, any fuel can do it, even the lowest efficient fuel can do that, just by making the burning
surface area so large that it finishes in split of a second generating hell of a thrust.
But that may not be what you want, the best propellants are perchlorate-metal fuel-binder. High powered propellants like APCP for example, have a peak
specific impulse when you mix 72% NH4ClO4, 16% Fine aluminum powder, and 12% PU, HTPB, or any liquid rubber that can be cured and turn hard, and can
burned good.
If you only have nitrates, aka easiest oxidizers to find.. then. in my experience, you can give 65% KNO3, 20% Dextrose, 15% Magnesium powder, a try.
The magnesium get tripple reacted with O produced by KNO3, H2O and CO2 produced by dextrose when burned with KNO3, the tripple reaction makes the
propellant burn very very hot, the magnesium could reach as high as over 2200 degree Celsius when burned with CO2. The heat produced can make a lot of
gas expansion and making nitrate based propellants' highest specific impulse. Note that KNSU burns only with 1400 degree celsius.
The dextrose could be replaced with Epoxy binders, if you want, but then the KNO3 ratio have to be raised to around to at least 68%. I tried Araldite,
Ace, and some other, gave me a ugly 40% Carbon residue.. I personally tried a similar propellant using epoxy. For epoxies its best if you use West
system 305 slow resin.
70% KNO3 5% Magnesium 16% Epoxy and 9%Sucrose. The CO2, H2O produeced by Sucrose and by Epoxy, and O by KNO3 could all react with Magnesium which in
turn should have gave me a good thrust but i had some problem during ignition of this propellant, i just did this yesterday, so the whole thing burned
for 7 seconds instead of 3 seconds expected, gave me a low thrust of just being able to take off at its peak. and the Long during of the hot burning
magnesium has erroded my Concrete-Epoxy nozzle, severly, taking off around 2mm of thickness on all side, with some melted PVC.
I discussed about Nitrate-CO2-H2O producing fuel- and Magnesium with Richard Nakka. here is the conversation.
Richard nakka and me talking about RNX.
________________________________________________________________________________________________________________
I wrote:
I recently found a that a mixture of alcohol, toluene, and acetone, can dissolve most of the epoxy. That sounds very very interesting, because we
will be able to mix KNO3 with those house hold solvents to get a much better and efficient RNX propellant ?
TZ
Richard wrote:
I don't believe that will help. The problem is that KNO3 is a low-energy oxidizer and that is why the combustion efficiency is not great. Especially
since RIO has to be added to get stable combustion, which further reduces the potential.
The only realistic solution to boosting the potential of RNX is to added aluminum or magnesium. These metals are "thermics" which react with the H2O
that is produced by the combustion of RNX, and greatly increase the temperature. But, a fair amount would be needed to 'self-sustain' the high
temperature combustion, no less than 10-15% (experimentation would be needed). I would expect as much as 25% can be used and efficiently burned.
Richard
________________________________________________________________________________________________________________
Yup, However, All magnesium turns to MgO, that stays as a SOLID when burned, however it gives a really boost in gas expansion with its heat produced
when reacted with CO2. MgO will be pushed out with no thrust gained and your nozzle might face some difficulties when MgO is passing through your
throat at over mach 3, i assume thats the least exhaust velocity you need to get your rocket up over 100ms. I used a Chromium-Iron alloyed washer that
actually did not melt(surprised) when i added 5% Magnesium.
However magnesium can make up for its 2 phaese flow lose, by boiiling the carbonates produced by nitrate propellant. Adding magnesium is that when it
burns, it can actually boil K2CO3 which is greatly produced by KNO3, and turning it to gas. and the higher temperature could make more gas expansion i
would assume the best Nitrate propellant could reach a specific impulse of around 180.
|
|
|
Practicaler
Harmless
Posts: 42
Registered: 24-3-2012
Member Is Offline
Mood: Exploding
|
|
I have potassium nitrate and painting grade aluminum powder and I also do have potassium chlorate and benzoic acid and sodium benzoate . . . Well
konkrete rocketry will you please tell me what is the best fuel that can be madr with potassium nitrate sucrose and aluminum. OR with potassium
chlorate or potassium permangante or sodium nitrate or anything which can be used to do my work i dont have any any access to perchlorates but nitrate
are in plenty for me. Chlorate supplyis also limited . Basically i want to make such a rocket which can Carey at least 3kg of load with it
|
|
|
KonkreteRocketry
Hazard to Others
Posts: 165
Registered: 12-11-2012
Location: Dubai
Member Is Offline
Mood: No Mood
|
|
Quote: Originally posted by Practicaler  | | I have potassium nitrate and painting grade aluminum powder and I also do have potassium chlorate and benzoic acid and sodium benzoate . . . Well
konkrete rocketry will you please tell me what is the best fuel that can be madr with potassium nitrate sucrose and aluminum. OR with potassium
chlorate or potassium permangante or sodium nitrate or anything which can be used to do my work i dont have any any access to perchlorates but nitrate
are in plenty for me. Chlorate supplyis also limited . Basically i want to make such a rocket which can Carey at least 3kg of load with it
|
Chlorate burns too fast and is instable, try not take so much load with it, 3kg is kind of... over load.
If you ever make a nitrate rocket, use this.
60% KNO3
30% Sucrose
10% Magnesium.
48 KNO3 + 5 C12H22O11 = 24 K2CO3 + 24 N2 + 55 H2O + 36 CO2
The H2O, CO2, and N2 burned from the sugar and KNO3 will burn with magnesium violently.
Mg + N = Mg2N3
Mg + CO2 = CO + MgO
Mg + 2H2O = Mg(OH)2 + H2
Mg + O = MgO
Those reactions from magnesium will BOOST the nitrate propellant by a lot, boiling off the K2CO3 also. This is the highest specific impulse ever made
by KNO3.
|
|
|
Practicaler
Harmless
Posts: 42
Registered: 24-3-2012
Member Is Offline
Mood: Exploding
|
|
Making magnesium powder is a big trouble for me but getting aluminum powder is much easy. Will it do my work . In my knowledge Al doesn't react with
nitrogen
|
|
|
KonkreteRocketry
Hazard to Others
Posts: 165
Registered: 12-11-2012
Location: Dubai
Member Is Offline
Mood: No Mood
|
|
| Quote: Originally posted by Practicaler | | Making magnesium powder is a big trouble for me but getting aluminum powder is much easy. Will it do my work . In my knowledge Al doesn't react with
nitrogen |
in nitrates, both aluminum and magnesium dont turn into gas in its oxidized state, but magnesium is more reactive so use magnesium for nitrates.
|
|
|
KonkreteRocketry
Hazard to Others
Posts: 165
Registered: 12-11-2012
Location: Dubai
Member Is Offline
Mood: No Mood
|
|
Check this, i did this static test 2 days ago. I could have reached a maximum speed of 82 meters /s with this.
I added 5% Magnesium to KNSU, surprisingly , the specific impulse i got from my calculation was 169. a typical KNSU would produce 130 max. I had a
delaval nozzle though.
https://www.facebook.com/photo.php?v=10152738867955707
[Edited on 10-4-2013 by KonkreteRocketry]
|
|
|
Trotsky
Hazard to Others
Posts: 166
Registered: 6-2-2013
Location: US
Member Is Offline
Mood: No Mood
|
|
I've had good luck with rocket candy produced using 7% Al and 10% AN. My KN was somewhat more coarse than I would have liked, but the AN was
ultrafine.
I had problems getting it to ignite, though. I ended up sticking a small bit of straight KNSU into the nozzle and ignited that, which had no problems
getting the primary charge going.
I experimented with KMnO4+Paraffin and KMnO4 + Epoxy motors with varying amounts of AN, charcoal and Al added. With paraffin it was impossible to get
an even distribution and even consistency. Paraffin-based motors were sub-par to garbage, but it was kind of fun, and the flame had a neat color. In
retrospect, though, it was stupid as I was inhaling neurotoxic Mn fumes at dangerous levels.
|
|
|
Thebrain
Harmless
Posts: 14
Registered: 26-5-2012
Member Is Offline
Mood: indignant
|
|
How big a payload are you looking at? One thing to consider is that the larger your payload, the more fuel you'll need. And fuel is heavy too. It will
cut into your payload capacity.
|
|
|
Fantasma4500
International Hazard
Posts: 1681
Registered: 12-12-2012
Location: Dysrope (aka europe)
Member Is Offline
Mood: dangerously practical
|
|
i believe also golden powder could be used, but im not entirely sure, you would ofcourse need to press it..
burns quite fast and ignites really fast..
i had decreased the burn speed of golden powder with mixing it 1:1 by volume with 60:40 KNO3 Sugar
meaning..
6g KNO3 4g ascorbic acid
6g KNO3 4g sugar
if i had better location for playing with rockets i would most likely do it, my idea would be making a goldenpowder-blackpowder type, also i have
found out that golden powder can be made with KClO3, so pretty surely also KClO4, tho its very insoluble.. other perchlorates like NaClO4 if possible
to get perhaps?
mixing metal powder into the golden powder seems to make it worse, but perhaps the idea of the metal powder reacting with the gas produced could make
a difference..
as konkreterocketry states i agree, you need to think about the rocket's design mostly.. the more burn area the better
abit more interesting as i see it is kicking off the rocket as used in military weapon systems.. ive heard this being talked about as ''softlaunch''
or something, where the projectile/rocket is first shot off as in a mortar, with little force, but this needs fins to work properly, as it stabilizes
the rockets flight alot, apparently also. then a proper timing with rocket fuel initiation..
for things like this golden powder could be used or crimson powder, lovely stuff, havent tried anything else but heating some in a capped aluminium
tube, made a not so impressive bang and a decent shot tho it went through what covered up one end of the tube, it shows potential..
|
|
|
Vikascoder
Hazard to Others
Posts: 309
Registered: 28-1-2012
Member Is Offline
Mood: No Mood
|
|
What fuel is used in rpg launcher. You could try that for your work I think in RPG most probably ammonium perchlorate and aluminum is used .
Girls break promises like a small child breaks pencil tips so don't trust girl bcoz no girl=no tension
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
