holmes1880
dushbag
Posts: 194
Registered: 13-12-2010
Location: http://highexplosivesforum.forumotion.com/
Member Is Offline
Mood: Egregious
|
|
Nitromethane Sensitizers and Det Cord
Has anyone read or seen a documented reference of hexamine, aka fuel starter tablets, being used to sensitize NM to become sensitive to detonation?
I found it sort of "referenced" in this document, but I am not sure whether it is the hexamine I have in mind- after all, people say it's hard to
dissolve in NM. According to the paper, it can det
http://www.dtic.mil/cgi-bin/GetTRDoc?Location=U2&doc=GetTRDoc.pdf&AD=ADA276962,
Since ethelenydiamine (EDA) or morpholine is so problematic to come by, hexamine would be a desired substitute for sensitizing NM to be useful in
small CD amounts.
[Edited on 7-6-2011 by holmes1880]
|
|
|
franklyn
International Hazard
Posts: 3026
Registered: 30-5-2006
Location: Da Big Apple
Member Is Offline
Mood: No Mood
|
|
Operational circumstances are succinctly stated on page 10 of the cited reference.
12 mm is critical diameter when strongly boosted. The table on page 9 lists one
Hexamine shot , less than 3 % by volume , yielding 6640 m/s. Not considered is
the effect of voids ( bubbles ) to sensitize NM.
Having a deficit of oxygen , blending with an oxidizer as in the case with Kinepak ,
would seem more fruitful in improving performance and reducing critical diameter;
although the poor character of ammonium nitrate actually degrades v.o.d. in this
particular case. The acid character of nitromethane may solvate sodium nitrite to
form nitrous acid and the nitronate sodium salt, rendering it sensitive. Blending with
dinitrogen tetroxide should give very good results. Hi test hydrogen peroxide also.
.
[Edited on 8-6-2011 by franklyn]
|
|
|
holmes1880
dushbag
Posts: 194
Registered: 13-12-2010
Location: http://highexplosivesforum.forumotion.com/
Member Is Offline
Mood: Egregious
|
|
So you're seeing them use hexamine too. That will be my 1st test.
Yes, blending it with AN could help to sensitize, but I need it to maintain its low viscosity so as to be injected in a 6-10mm vinyl tube with a
syringe. If it has a gel consistency and/or have grains - it will become problematic.
|
|
|
PHILOU Zrealone
International Hazard
Posts: 2893
Registered: 20-5-2002
Location: Brussel
Member Is Offline
Mood: Bis-diazo-dinitro-hydroquinonic
|
|
Hexamine (CH2)6N4, is a discrete and stable form of NH3 and CH2=O.
It is possible that:
1°) Hexamine is mildly basic and as such favourise somehow the formation of some nitronic variant of nitromethane rendering it more sensitive.
(CH2)6N4 + CH3-NO2 <==> (CH2)6N4H(+) + CH2=N(=O)(-O-)(-)
It must be very discrete but if it happens a little yellow/orange colourization should occure (maybe only noticeable via spectrophotometry)
2°)Hexamine hydrolyses/decompose a bit into its constitutive elements NH3 and CH2=O:
-The NH3 is more basic than hexamine and might form the nitronate salt and sensitise NM, but also microbubbles also sensitising the stuff.
-The CH2=O might react with nitromethane in basic media to form some
HO-CH2-CH2-NO2 and CH2=CH-NO2
(HO-CH2-)2CH-NO2
(HO-CH2-)3C-NO2
so contributing to the decomposition and shifting of hexamine into formaldehyde scavenging and amonia liberation.
Again this must be visible via color change or spectrophotometry.
Amonia or hydrazine and CH3-NO2 turn very fast yellow-orange-brown...but concentrations I have used are high (>25%)...in this case from hexamine it
could be less than 1% of 3% (= 0.03%)
PH Z (PHILOU Zrealone)
"Physic is all what never works; Chemistry is all what stinks and explodes!"-"Life that deadly disease, sexually transmitted."(W.Allen)
|
|
|
holmes1880
dushbag
Posts: 194
Registered: 13-12-2010
Location: http://highexplosivesforum.forumotion.com/
Member Is Offline
Mood: Egregious
|
|
Thank you for that. Indeed, I mixed a small quantity of NM with a 5% cleaning ammonia and it gained yellow tinge, as well as created some oily yellow
bubbles within it. It failed to detonate, however, since I was only using a #8 cap and CD was 6.5mm in the tube.
My hope is that hexamine is approximately as effective as EDA or morpholine, that was referenced within the paper to be able to sensitize NM to 6mm
CD. I think it's very lazy of those researchers to have tested 12mm diameter, but then say: "well, the critical diameter is somewhere below 12mm". Now
I have to do the leg work.
|
|
|
pjig
Hazard to Others
Posts: 179
Registered: 25-5-2010
Member Is Offline
Mood: always learning
|
|
I think that one prob is the % of the ammonia. If Im correct the patents out there use a 20% + strength ammonia. Household ammonia may work, but I
have never herd of it being used in that low of strength as a sensitizer.
|
|
|
holmes1880
dushbag
Posts: 194
Registered: 13-12-2010
Location: http://highexplosivesforum.forumotion.com/
Member Is Offline
Mood: Egregious
|
|
Yep. I frankly couldn't determine even the % the ammonia had- could have been 10% or 30%- no clue.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
