SelfStarter
Harmless
Posts: 14
Registered: 19-10-2010
Member Is Offline
Mood: No Mood
|
|
Reusing leftover Zn from Zn/HCl reduction
I was wondering if anyone can think of any reason why zinc remaining after a Zn/HCl reduction of a nitrostyrene couldn't be used again for the same
purpose. I wash the zinc a few times with H20 anyway or else it gets very hot. In Hudlicky's Reductions book it says that zinc used in a Zn/HCl
reduction can catch fire sometimes but I haven't had any problems after washing it 3x with H20. Now as far as using it for the same reaction would it
cause any problems?
|
|
mr.crow
National Hazard
Posts: 884
Registered: 9-9-2009
Location: Canada
Member Is Offline
Mood: 0xFF
|
|
Should be fine
I can imagine the surface of the Zn would be etched making it extra reactive towards the air.
Double, double toil and trouble; Fire burn, and caldron bubble
|
|
Magic Muzzlet
Hazard to Others
Posts: 146
Registered: 22-7-2010
Member Is Offline
Mood: No Mood
|
|
Yes you can reuse it, I once even did it myself when low on zinc dust.
|
|
Arthur Dent
National Hazard
Posts: 553
Registered: 22-10-2010
Member Is Offline
Mood: entropic
|
|
That should be no problem. When zinc is dipped in HCl, the reaction is quite intense and it etches the surface of the metal quite well, making it
spotless.
After a few good rinses, to remove the excess HCl and zinc chloride impurities, your zinc should be perfectly good for any other experiment. All my
zinc supply at home has been treated that way.
Robert
--- Art is making something out of nothing and selling it. - Frank Zappa ---
|
|