Sciencemadness Discussion Board
Not logged in [Login ]
Go To Bottom

Printable Version  
Author: Subject: Ca(OH)2 + H2O2 --> ?
guy
National Hazard
****




Posts: 982
Registered: 14-4-2004
Location: California, USA
Member Is Offline

Mood: Catalytic!

[*] posted on 14-4-2004 at 22:58
Ca(OH)2 + H2O2 --> ?


What does Calcium hydroxide and H2O2 make? I've done it and lots of bubbles form, and the calcium turns yellow. What is the "yellow calcium"?
View user's profile View All Posts By User
Pyrovus
Hazard to Others
***




Posts: 241
Registered: 13-10-2003
Location: Australia, now with 25% faster carrier pigeons
Member Is Offline

Mood: heretical

[*] posted on 15-4-2004 at 01:26


H2O2 is quite unstable in alkaline solution, so your bubbles come from the reaction 2H2O2 -> H2O +O2. I'm not too sure about the yellow colour though - how pure is your calcium hydroxide?



Never accept that which can be changed.
View user's profile View All Posts By User
guy
National Hazard
****




Posts: 982
Registered: 14-4-2004
Location: California, USA
Member Is Offline

Mood: Catalytic!

[*] posted on 15-4-2004 at 10:31


It should be 99-100% pure
View user's profile View All Posts By User
The_Davster
A pnictogen
*******




Posts: 2861
Registered: 18-11-2003
Member Is Offline

Mood: .

[*] posted on 15-4-2004 at 13:08


I seem to remember reading a patent a while ago which involved adding H2O2 to a zinc hydroxide solution in ammonia to yield zinc peroxide. This could have been what happened to you, except the calcium analog. You may have made calcium peroxide:o. I'm not 100% sure on this though.
View user's profile View All Posts By User
blip
Hazard to Others
***




Posts: 133
Registered: 16-3-2003
Member Is Offline

Mood: absorbed

[*] posted on 15-4-2004 at 15:12


Undoubtedly much of your H<sub>2</sub>O<sub>2</sub> decomposed, but some may have formed CaO<sub>2</sub> due to its relative insolubility (said to be insoluble in the reference doc). It is described as being "White or yellowish powder". If you did this in a covered container so that dust could not enter and the container couldn't somehow break down in any way like a cheap cup might, then some possibilities are eliminated. I once tried this, but I was unable to continue when the froth began pouring out of the container and I had to dump it out in the sink. :(
http://www.chem-world.com/pdf/calcium-peroxide-msds.pdf




View user's profile View All Posts By User
The_Davster
A pnictogen
*******




Posts: 2861
Registered: 18-11-2003
Member Is Offline

Mood: .

[*] posted on 15-4-2004 at 20:12


I tried this reaction with sodium hydroxide and hydrogen peroxide. I got some bubbling, the beaker heated up a bit, I left it for a while and now, I have a crystaline precipitate. Could this be sodium peroxide.:o I sort of doubt that it is because I remember reading that sodium peroxide reacts with water to give concentrated H2O2, so I probally just have some sodium hydroxide that re-crystallized that was only soluble when the beaker heated up.:(
View user's profile View All Posts By User

  Go To Top