3DTOPO
Hazard to Self
Posts: 64
Registered: 14-2-2016
Member Is Offline
Mood: No Mood
|
|
Hacking up a 2000C-3000C pyrometer?
It is quite expensive to buy a infrared pyrometer capable of measuring over ~1000C.
I have an idea for making one out of an inexpensive 1000C rated pyrometer. What do you think would happen if I put a welding glass over its sensor? Or
acetylene smoked glass?
Seems like after covering it, I could "calibrate" it with materials of a known melting temperature. Would it work in reliable linear way if I had two
calibration points? e.g. melt iron for point one and titanium for point two?
Any thoughts/ideas? Thanks!
|
|
|
3DTOPO
Hazard to Self
Posts: 64
Registered: 14-2-2016
Member Is Offline
Mood: No Mood
|
|
Limiting the aperture seems to do the trick - with my first crude test. Something it says is 430F without the mask reads 300F with the mask.
I will try 3D printing an accurately sized one. Perhaps if I use say half the factory calibrated aperture, I could then just double the values of the
readout?!?
I follow up after more experiments.
|
|
|
yobbo II
National Hazard
Posts: 764
Registered: 28-3-2016
Member Is Offline
Mood: No Mood
|
|
Perhaps if you attach an optical fiber the the device it would act a an accurate hole and also make the device more easy to use as you are now placing
the end of a fiber at the temperature source. You would probably need a lens though at the fiber end would would not be so simple to do.
http://www.explainthatstuff.com/how-pyrometers-work.html
The 'manual' pyrometer sounds good but they say it needs regular calibration and skill to use.
|
|
|
yobbo II
National Hazard
Posts: 764
Registered: 28-3-2016
Member Is Offline
Mood: No Mood
|
|
http://www.metallab.net/pyrometer.php
Homemade hot wire pyrometer.
|
|
|
Texium
|
Thread Moved
22-11-2023 at 20:14 |
![[*]](images/xpblue/default_icon.gif){kind=icon}
