RedFox
Harmless
Posts: 6
Registered: 2-1-2014
Member Is Offline
Mood: 99 problems but my mood aint one
|
|
Stopcock Size help please
Hi Guys/Girls
ive recently obtained a addition funnel without the stopcock, looking at the socket it has 4 written on it, i have tried to find the company who made the glassware "SGA Scientific inc" but have had no luck, i have UTFSE
and google but all i can come out with is stopcocks wich specify "4" but this looks like it may refer to the bore size through the stopcock itself, i
cant find any information with any dimensions about " "or anyone selling stopcocks buy this spec. any help to a retailer that sells by this "dimension" (or if anyone has a second
hand one they would consider selling?) or a link pointing me in the correct direction would be greatly appreciated!
![](http://imageshack.us/a/img585/9823/854q.jpg)
[Edited on 2-1-2014 by RedFox]
|
|
Dr.Bob
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2690
Registered: 26-1-2011
Location: USA - NC
Member Is Offline
Mood: No Mood
|
|
That says TS 4, taper standard #4. I think that is about 40 mm long on the stopcock length and it is about 15 mm diameter at the narrow end and ~18mm
dia at the wider end. I likely have some used ones, if you are interested, or they sell them at several sites, at insanely high prices, one is below
for example. If you want a used one, send me a u2u.
http://www.gogenlab.com/products/pyrex-r-ts-straight-bore-st...
|
|
RedFox
Harmless
Posts: 6
Registered: 2-1-2014
Member Is Offline
Mood: 99 problems but my mood aint one
|
|
Ah is see. PS made no sense to me TS sounds better. thanks for the reply, have U2U'd you!
|
|
RedFox
Harmless
Posts: 6
Registered: 2-1-2014
Member Is Offline
Mood: 99 problems but my mood aint one
|
|
please excuse the double post, just went back to check the marking (just to be sure i wasnt starting to loose my head or sight) clearly printed "P"
(please see below pic of better image). not sure what kind of spec that is or maby a misprint?. anyways, have measured the socket and have overall
30mm length, 18mm at the big end and 12mm at the small end.
![](http://imageshack.us/a/img11/3161/jtfyu.jpg)
|
|
Dr.Bob
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2690
Registered: 26-1-2011
Location: USA - NC
Member Is Offline
Mood: No Mood
|
|
Is the inside ground or smooth, it looks pretty smooth. That might be a Teflon stopcock joint, I have never seen them labelled PS, but who knows.
None of the stopcocks I have are numbered but the standard Teflon stopcock on larger sep funnels is 28-29 mm long, smaller diameter end is 12mm, the
larger one is 18mm in diameter. I have lots of those.
|
|