chelu55
Harmless
Posts: 2
Registered: 10-11-2013
Member Is Offline
Mood: No Mood
|
|
Vacuum Pump Question
Hey everyone,
I am conducting a study to evaluate the elasticity of rubber stoppers on drug vials after multiple needle punctures. However, I have not done this
experiment before and the protocol requires me to reduce the vacuum chamber pressure to 27 kPa (~4 psi). Any advice on they best type vacuum
approach?
After researching vacuum pumps I think a water aspirator will not produce enough pressure. Correct? If so, my next thought is purchasing as vacuum
pump. However, these cost hundreds of dollars. Does anyone have any insight on the best vacuum method to reach pressures of 27 kPa? Any help is
appreciated. Thanks!
|
|
Magpie
lab constructor
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 5939
Registered: 1-11-2003
Location: USA
Member Is Offline
Mood: Chemistry: the subtle science.
|
|
If your tap water is reasonably cold you should be able to pull a vacuum down around 1 psi. Or:
http://www.harborfreight.com/25-cfm-vacuum-pump-98076.html
The single most important condition for a successful synthesis is good mixing - Nicodem
|
|
chelu55
Harmless
Posts: 2
Registered: 10-11-2013
Member Is Offline
Mood: No Mood
|
|
Thanks Magpie! Looks like the vacuum pump is the way to go. I appreciate your help!
|
|
Dr.Bob
International Hazard
![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif) ![*](images/xpblue/star.gif)
Posts: 2690
Registered: 26-1-2011
Location: USA - NC
Member Is Offline
Mood: No Mood
|
|
You could buy a diaphram pump from Ebay for a few hundred that might work fine. They are ideal for that PSI range if you don't need a lot of flow.
Gast, KNF, vacumbrand, and others are all fine, but buy one that is promised to be working, and not cheap kit.
http://www.ebay.com/sch/i.html?_trksid=p2050601.m570.l1313.T...
|
|