obeliscus - 21-7-2016 at 15:10
Hello
I have a Talboy's engineering bodine stirrer motor and found that my stirring rod does not attach nor fit snugly into the attachment fixture.
I sent a message to the ebay seller over this concern and I was told that I needed a 1/4 inch coupler.
I have looked at several types of 1/4 inch couplers and I am unsure as to which coupler would work.
I will attach photos of the rod and motor.
[Edited on 21-7-2016 by obeliscus]
Magpie - 22-7-2016 at 06:04
I had to buy a chuck at Ace hardware, then an adapter atMcMaster-Carr mail order. my mixer is not a Talboy, however.
obeliscus - 22-7-2016 at 07:58
Do you know what sort of chuck?
Correction: Jacobs
Magpie - 22-7-2016 at 13:33
Jacobsen iirc.
[Edited on 23-7-2016 by Magpie]
obeliscus - 23-7-2016 at 19:45
Thanks I will go check it out.
Magpie - 24-7-2016 at 13:03
3D printer shaft coupling may be useful. Also see:
http://www.walmart.com/ip/TALBOYS-191C-Talboys-Jacobs-Chuck-...
[Edited on 25-7-2016 by Magpie]
obeliscus - 24-7-2016 at 20:13
update:
I just discovered after 3 test uses that my motor has died; it looks like I will have to get a new one.