Sciencemadness Discussion Board

allyl hexanoate - pineapple ester

Fery - 14-10-2021 at 11:57

another beautiful pineapple scenting ester

63,5 g of hexanoic acid (0,55 mol)
47,8 g 80-90% allyl alcohol (I used a fraction boiling from b.p. of azeotrope to b.p. of anhydrous allyl alcohol which I collected as a forerun before main anhydrous allyl alcohol fraction started to distill) (40,6 g of 100% alcohol if asssuming 85% alcohol = 0,70 mol = slight excess, 0,15 mol more = 8,7 g of alcohol are allowed to be lost until esterification with removal of all water, water present 15% * 47,8 = 7,2 g)
20 ml isohexanes, b.p. 60-65 C (medicinal petrolether, hydrogenated benzin) must be more than the volume of Dean-Stark trap apparatus
0,5 ml 96% H2SO4 (catalyst, no need more, maybe half would be enough too)

To 250 ml RBF was poured 63,5 g of hexanoic acid + 47,8 g 80-90% allyl alcohol + 20 ml isohexanes + 0,5 ml 96% H2SO4. Boiling stones (glass balls) added, 10 ml Dean-Stark trap apparatus attached with condenser and the reaction mixture was refluxed. After 1 hour 21,0 g removed from the trap (9,9 g reaction water, 7,2 g water present in 85% allyl alcohol and remaining 3,9 g should be allyl alcohol loses which is below the used 8,7 g excess of the allyl alcohol). No more bottom phase collected after extra half an hour of refluxing.
Cooled down to room temperature, transferred into 250 ml separatory funnel.
Washed with:
washed with 100 ml of cold tap water
washed with 100 ml of cold tap water, emulsion formed, broken by addition of 50 ml of 5% NaHCO3, effervescence of CO2, sep funnel venter much more frequently than when washing with only H2O
washed with 75 ml of 5% NaHCO3
washed with 75 ml of 5% NaHCO3, when it stopped evolving pressure and CO2 it was a sign that all the H2SO4 and possibly unreacted hexanoic acids were removed, emulsion of water bottom phase observed, gently moving (not shaking) helped to break the emulsion faster
washed with 100 ml of tap H2O, emulsion, broken by occasional gentle moving (1 hour required)
washed with 100 ml of tap H2O, emulsion, broken by occasional gentle moving (1 hour required)
Upper phase always kept and bottom water phase discarded.
Transferred into 250 ml FBF, added anhydrous Na2SO4 and magnetically stirred for 1 hour, let to sit overnight and the next day again magnetically stirred for 1 hour.
Filtered into 250 ml RBF through a glass funnel with a plug of mineral cotton.
Isohexanes distilled out using water aspirator vacuum.
Distilled using oil rotary vacuum pump at pressure approximately 4 kPa (-96 kPa when valve fully closed, -92 kPa when valve partially open during ditillation), main fraction collected 74-75 C, yield 66,3 g 77% (first 10 ml forerun separated, residuum in flask cca 5 ml). Oil bath temp 110-115 C.



apparatus for the reaction

IMG_20211012_153532_2.jpg - 29kB



the level of upper isohexanes phase and bottom water + a little of allyl alcohol phase, I had to drain the bottom phase more times as my Dean-Stark trap apparatus has only 10 ml volume, I collected totally 21,0 g of mixture of water + allyl alcohol (that's why I used excess of allyl alcohol for the esterification) during 1 hour, then no more bottom phase collected after extra half an hour of reflux

IMG_20211012_155403_2.jpg - 17kB



first washing with tap water, no problem in separation, the organic phase is very dark as I used 2 years old hexanoic acid which was in original plastic bottles (2x35 ml, https://fichema.cz/produkty/1565-kyselina-kapronova-35-ml-85...), maybe using less of H2SO4 catalyst could also help in less dark organic phase?, but no worry, crystal clear product obtained after the final distillation

IMG_20211012_184516_9.jpg - 33kB



second washing with tap water, nasty emulsion

IMG_20211012_185621_7.jpg - 44kB



the emulsion was broken by adding 50 ml of 5% NaHCO3 (CO2 effervescence and increasing of pressure in the separatory funnel)

IMG_20211012_191359_2.jpg - 38kB



third washing, with 75 ml of 5% NaHCO3, no problem

IMG_20211012_193938_6.jpg - 43kB



fifth washing, with 100 ml of tap water, emulsion again, to break it a weak movement with the separatory funnel helped (not shaking!), the same on sixth final washing with 100 ml of tap water

IMG_20211012_200100_2.jpg - 41kB IMG_20211012_202456_5.jpg - 46kB IMG_20211012_203150_3.jpg - 39kB IMG_20211012_203335_5.jpg - 40kB



vacuum distillation, I had to partially open the valve to reduce the vacuum strength of my vacuum pump, the fraction collected boiling in range 74-75 C at vacuum level approximately 4 kPa (the manometer showed -92 kPa and when the valve fully closed it shows -96 kPa, it is 2-stage oil rotary vacuum pump capable of vacuum below 1 Pa at which the manometer shows -96 kPa)

IMG_20211014_170756_6.jpg - 44kB IMG_20211014_180535_8.jpg - 16kB



video of vacuum distillation:
https://www.youtube.com/watch?v=lieDF_4KgNE